User's Manual

RCU Operation Manual

1. MUTE Button

Press and release MUTE button to turn off the audio for any alert. When an

audio alert is sounded, you can silence the alarm by pressing MUTE button.

Press MUTE button again to turn on the audio alert.

2. Mark Button

Press and release MARK button to memory the location you have selected.

This location is stored in the memory and give an audio alert when you pass

the marked location.

3. Volume Up Button

Press Volume Up button to increase the audio volume.

4. Volume Down Button

Press Volume down button to decrease the audio volume.

5. CITY/HIGHWAY Button

City mode reduces the annoyance of false alerts typically encountered in

urban driving areas.

Highway mode provides full audio warning any time radar(X, K, Ka) or

laser signals are detected, and is recommended for open road driving.

6. Power Button

Press and release the POWER button to turn the unit on or off.

PAGE 1
RCU Operation Manual 1. MUTE Button Press and release MUTE button to turn off the audio for any alert. When an audio alert is sounded, you can silence the alarm by pressing MUTE button. Press MUTE button again to turn on the audio alert. 2. Mark Button Press and release MARK button to memory the location you have selected. This location is stored in the memory and give an audio alert when you pass the marked location. 3. Volume Up Button Press Volume Up button to increase the audio volume. 4.
PAGE 2
INSTALLATION Mounting Guidelines • Mount the RCU near the driver’s seat or host board. • Do not mount your unit behind any objects. These obstructions have metal surfaces which can affect communication with host board. • To reduce the possibility of theft, conceal your unit when not in use. • Make sure the mounting location you have chosen is relatively level and is clean and dry. Clean with isopropyl alcohol if necessary to remove any waxes or polishes. • Separate the fastener strips.
PAGE 3
SPECIFICATIONS Carrier Frequencies: 433.92 MHz (Single Channel) Frequency Stabilization Scheme : High-Q SAW Resonator Stabilization Modulation Method : Amplitude Shift Keying (By Carrier ON/OFF) Bit Duration : “1” – 2.25msec / “0” – 1.125msec Operating Temperature Range: -10° C to +80° C Storage Temperature Range: -20° C to +90° C Power Requirements: 3 V CR2032-type Li-Battery FCC INFORMATION This device complies with part 15 of the FCC Rules.