Home Unit Installation and Operation Guide
Information in this documentation is subject to change without notice and does not represent a commitment on part of Elmo-Tech Ltd. The software described in this document is subject to the license agreement that is included with the product, which specifies the permitted and prohibited uses of the product. Any unauthorized duplication or use of this documentation, in whole or in part, in print, or in any other storage or retrieval system is prohibited.
Table of Contents 1 Getting Started ............................................................... 3 About This Manual ............................................................ 3 2 Installation & Activation Instructions ............................. 5 Locating the Home Unit ..................................................... 6 Activating the Home Unit ................................................... 6 3 Maintaining & Packing the Monitoring Equipment ........... 9 Cleaning the Home Unit .......
STaR Unit & Transmitter Installation and Operation Guide List of Figures Figure 1 Home Unit ....................................................................5 Figure 2 Locating the Home Unit ..................................................
1 Getting Started About This Manual The Home Unit Installation and Operation Guide has been created for the installation expert and is meant as a guide through the installation and operational procedures. This manual assumes that you have at least some experience with electronic monitoring systems. This manual does not contain information regarding system settings, configuration or any other software produced by Elmo-Tech Ltd., unless directly related to this produce.
2 Installation & Activation Instructions Figure 1 Home Unit 5
1Track Home Unit Installation and Operation Guide Locating the Home Unit Place the Home Unit as close to the center of the curfew location as possible, 3 ft (1 m) off the ground and at least 1 foot (30 cm) away from the wall. Figure 2 Locating the Home Unit Activating the Home Unit To activate the Home Unit: Connect the adapter end of the external power cable to the power outlet. The Home Unit makes three audible beeping sounds.
1Track Home Unit Installation and Operation Guide The Charge and Power LED’s light up only after the backup battery is fully charged. The Home Unit is now in monitoring mode. To deactivate the Home Unit: 1. Using a screwdriver, unscrew and remove the Unit holding screw located on the underside of the mounting bracket. 2. Disconnect the Home Unit from the mounting bracket by pulling the Unit upwards slightly. 3. Remove the Home Unit from the mounting bracket and turn the Unit over.
3 Maintaining & Packing the Monitoring Equipment Regular cleaning of your Elmo-Tech equipment is recommended, using Elmo-Tech approved products. After cleaning, Elmo-Tech recommends that you perform a visual inspection of all Units to check for cracks or any other damage, before redeploying into the field Cleaning the Home Unit To clean the Home Unit: 1. Remove the Unit from its carrying case. 2. Spray the surface of the Unit with an alcohol based cleaner (optional).
4 FCC Information FCC ID: LSQ-IDEU-830-4 FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT The equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.