User's Manual

ManualsBrandsAttenti ManualsElectronicsFall Detection Transmitter Unit

Part Number - 350100004 Revision – A00-000

Wireless Resident Monitoring Solutions 830

Fall Detection Unit Operational Instructions

The HomeFree system was designed to monitor special needs and Dementia

individuals in the care center environment. The Fall Detection Unit is one of the

many unique elements of this system.

The Fall Detection Unit is a small, battery operated device, connected to a chair or

bed monitoring mat, that can be used to notify care center staff members

whenever the resident gets out of the chair or bed. The Fall Detection Unit is

positioned on the chair or at the bedside.

The Fall Detection Unit is not for use

outside the monitored area.

Connecting the Fall Detection Unit

Plug the chair / bed /Incontinence mat into the mat connection jack, ensuring that

the cable between the mat and the Fall Detection Unit can move freely and is clear

of any moving parts.

The FDU-830 can be connected to the pressure pad and incontinence pad at the

same time but not the same units at same time.

Alarm Reset /

Bypass Button

Alarm Volume

Panel

Mats Connection

Jack

LED Indicator

Summary of content (4 pages)

PAGE 1
Part Number - 350100004 Revision – A00-000 Wireless Resident Monitoring Solutions 830 Fall Detection Unit Operational Instructions The HomeFree system was designed to monitor special needs and Dementia individuals in the care center environment. The Fall Detection Unit is one of the many unique elements of this system.
PAGE 2
Part Number - 350100004 Revision – A00-000 Place the chair / bed mat into its required position (refer to the placement instructions for the appropriate chair / bed mat). Place the Fall Detection Unit on the chair or at the bedside. Activating / Deactivating the Fall Detection Unit Insert the batteries in order to activate the Fall Detection Unit. Loosen the screw located on the back lower panel of the Fall Detection Unit and gently remove the cover. Insert the required batteries into the battery holder.
PAGE 3
Part Number - 350100004 Revision – A00-000 Detection Unit will continue monitoring once there is pressure on the chair / bed mat for more than 15 consecutive seconds. Bypassing the Fall Alarm Holding the Fall Detection Unit tightly, press the Reset button for approximately 5 seconds. The fall monitoring is deactivated for approximately 30 seconds (during the 30-second window, the green Status LED indicate bypass level selected).
PAGE 4
Part Number - 350100004 Revision – A00-000 The Fall Detection Transmitter Unit FDU-830-2 complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1) This device may not cause harmful interference and 2) This device must accept any interference received, including interference that may cause undesired operation. 3) Changes or modifications not expressly approved by Elmo Tech Ltd could void the user’s authority to operate the equipment.