PT-X5.2 User Manual Revision: 1.0.
Confidential Document Table of Contents 1. 2. 3. Introduction............................................................................................................................. 3 Package Contents .................................................................................................................... 3 Hardware ................................................................................................................................. 4 4. 5. Firmware Upgrade ...................
Confidential Document 1. Introduction Congratulations on your purchase of the PT-X5.2 asset tracking device! The PT-X5.2 is designed to be as easy to set up as it is to use. Hence, you can spend less time installation, and more time on the features you enjoy. There are no buttons, no controls and no inconvenience. Just charge the PT-X5.2 using the USB-to-Mini USB cable. The PT-X5.2 will send tracking data every 6 meters if the speed is less than 16km/h.
Confidential Document 3. Hardware 3.1.
Confidential Document 4. Firmware Upgrade In this section, we are going to demonstrate how to do firmware upgrade on the PT-X5.2 over a USB connection. Before doing the upgrade, connect the USB cable between the Mini-USB port of the device and the USB port on your computer. (1) Run HyperTerminal. Type a name for a new connection and click on the [OK] button.
Confidential Document (2) Select the correct COM port from the drop-down list and click on the [OK] button. (3) Port Settings should be as follows. Click on the [Apply] button and then click on the [OK] button to close the Properties Window.
Confidential Document (4) Click on [File] and select [Properties] Click on [Settings] and click on the [ASCII Setup...] button.
Confidential Document (7) Check the following options and type 500 for the Line delay. Click on the [OK] button to close the ASCII Setup window. Click on the [OK] button to close the Properties Window.
Confidential Document (8) Power ON the device and the startup message will be displayed on the screen. (9) Type the AT$FWDL command and press the [Enter] key on your keyboard.
Confidential Document (10) Click on the [Browse] button to browse the firmware file where you saved and select Ymodem from the Protocol drop-down list and click on the [Send] button. (11) From the following snapshot, the firmware file is being uploaded.
Confidential Document 5. Appendix 5.1.
Confidential Document 5.2. FCC Regulations This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
