User's Manual

ManualsBrandsAtoms Labs ManualsCamera & PhotoHD Outdoor PT Network Camera

QUICK START GUIDE

KIT CONTENT :

Camera Antenna

x 1

x 1x 1

Quick Start Guide

Power Adapter

x 1

PRODUCT OVERVIEW

SETUP THE CAMERA

For iOS

For Android

1. APP Download

Download and install the "OMGuard HD" APP to your device.

2. Power up The Camera

Connect the power wires to the adapter supplied, and wait until the RED LED indicator becomes

steady on. This process would be nished within 1 min and make sure the LED is ashing in RED.

3a.Wireless Connection

(1) In the Wi-Fi setting of your smart device. Choose the Wi-Fi router with prex of HD-xxxxxx

(xxxxxx=Camera ID numbers). Then enter the default password 12345678.

(2) Launch the APP, tap to add the camera.

(3) Tap (QR code icon) and scan the QR code label on the back of the camera to bring up the DID

information. Or tap "Search" to locate the camera.

(4) Enter the default password 123456.

(5) Tap “Save” when you done.

(6) Later, APP will request user to modify the default password to private password .

Note: Press and hold the “Reset” button for 5 seconds, the

system will be restored into factory default.

Pan/Tilt Wireless

Camera

x 1

Screw Pack

x 1

Rj45 Connect Jack

Micro SD Card Slot

Microphone

Antenna

Lens

Reset Button

Light Sensor

Mount Bracket.

Ethernet Cable

Power Cable

x 1

Hex Key

FRIENDLY REMINDER

- For video recording, BE SURE TO use CLASS 10 memory card or above (not included). Other kinds of

memory card may cause unexpected results and should be avoided.

- Anytime when you nd the camera pan/tile function does not perform properly, calibrate the camera

to get correct principle position (refer to step 8 of setup the camera section).

- For better performance, please enable the video hardware acceleration function. This function only for

Andriod (refer to the app introduction section).

AWF53

HD Outdoor PT Network Camera

Summary of content (3 pages)

PAGE 1
x1 x1 Hex Key Camera Antenna x1 x1 x1 x1 Rj45 Connect Jack Microphone Antenna Reset Button Micro SD Card Slot Power Cable Ethernet Cable Note: Press and hold the “Reset” button for 5 seconds, the system will be restored into factory default. Light Sensor Lens Mount Bracket. PRODUCT OVERVIEW - For video recording, BE SURE TO use CLASS 10 memory card or above (not included). Other kinds of memory card may cause unexpected results and should be avoided.
PAGE 2
Power Adapter Rj45 Connect Router then the advanced setting icon will appear on the screen. Enter Admin Password (default 123456) Choose the appropriate Wi-Fi router on your local network Note: If you fail to add the camera for several times, press and hold the “Reset” button for 5 seconds to reset it. Advanced (4) The Camera will offline for around 40 seconds to reboot for Wifi connection. When camera connects to Wi-Fi router correctly, the RED LED will stay ON.
PAGE 3
(2) 2 4 1 3 Note: Before mounting the camera, install the memeory card if you prefer recording to local storage. (1) Drill the mounting holes by using the aligmaent paper. (2) Insert 4 screw anchors into the wall. (3) Insert 2 screws into the screw anchors, reserved space 8 to 10 mm. Then Hang the camera on 2 screws. (4) Fasten 4 screws by using hex key. CAMERA INSTALLATION (1) In the camera list, tap the (2) Click the click box to enable video hardware acceleration.