User's Manual

QUICK START GUIDE
KIT CONTENT :
Optional item for limited models:
- Motion PIR - Window/ Door Contact - Panic Remote
Camera AntennaPan/Tilt Wireless
Appcam
x 1 x 1
Power Adapter
x 1
Quick Start Guide
x 1
x 1
Ethernet cable
HARDWARE OVERVIEW
SETUP THE CAMERA
Note: For video recording, BE SURE TO use CLASS 10 memory card or above (not included). Other kinds of memory card
may cause unexpected results and should be avoided.
For iOS
For Android
1. APP Download
Download and install the "OMGuard HD" APP to your device.
2. Power up The Camera
Power on the camera and wait until the GREEN LED indicator becomes steady on. This process would
be nished within 45 seconds and make sure the LED is ashing in GREEN.
3a.Wireless Connection
(1) In the Wi-Fi setting of your smart device. Choose the Wi-Fi router with
prex of HD-xxxxxx (xxxxxx=Camera ID numbers). Enter the default
password 12345678 and save the settings.
(2) Launch the APP, tap to add the camera.
(3) Tap (QR code icon) and scan the QR code label on the back of the camera
to bring up the DID information. Or tap "Search" to locate the camera.
(4) Enter the default password 123456 and save the settings.
(5) Later, APP will request user to modify default password to
private password .
3b.Wired Connection
(1) Make sure your smartphone is connected your Wi-Fi router.
(2) Connect the camera to the Wi-Fi router with an Ethernet cable.
(3) Launch the APP, tap the “Search” to locate the camera.
(4) Enter the default password 123456 and save the settings.
(5) Later, APP will request user to modify default password to private password .
Note:
In soft AP mode, the GREEN LED long ashes once followed by 2 short ashes. In normal mode, the LED
is ashing in green. For more details, please refer to the user manual.
4. Wi-Fi Setting
4a.
4b. The Camera will oine for around 40 seconds to reboot for Wi connection. When camera
connects to Wi-Fi router correctly, the Green LED will stay ON.
4c. In the Wi-Fi setting on your smart device again, make sure the Wi-Fi router you are connecting
to is the same as the camera. If not, manually assign to it.
Advanced
Enter Admin Password
(default 123456)
Choose the appropriate Wi-Fi
router on your local network
2
3
4
Note:
If you fail to add the camera for several times, please press and hold the “Reset” button for 5 seconds to reset it.
Then follow steps 3a or 3b again.
Steady ON
Mag
PIR
Panic Remote
Microphone
Micro SD Card Slot
Antenna
Power
Power LED
LAN Port
Reset
Lens
Light Sensor
Panic Remote