Owners Manual

ATOLL ELECTRONIQUE
IN200 Sig
ATOLL ELECTRONIQUE
OWNER’S MANUAL ~ INTEGRATED
Optional Digital Board
Page 5Page 4
The remote control is equipped with 2 Lithium CR2025 batteries. This remote control is also
able to drive all others ATOLL’s products: CD players, Tuners, Integrated or preamplifiers.
Warning: reduce the volume of the source connected to BYPASS before any use of the
BYPASS Input. The BYPASS input allows you to use your IN200 as a power unit (to be
connected to the output of an audio-video preamplifier, for example). This input is selected
via the front panel or by the BYPASS button on the remote control (hold 3 seconds). Once
this input has been selected, the word “BYPASS” appears on the screen and no other
function can be accessed by the remote control. To exit the BYPASS, press the BYPASS
button on the remote control for 3 seconds or use the source selector on the front panel
(18).
(1)
MUTE key: to get off the Mute, press any active key of the remote control or turn a
front knob.
(2)
Access to inputs OPT1 – OPT2 – COAX1 – COAX2 – USB – BT is only possible if
your appliance is equipped with the digital board.
1) Auxiliary input (optional phono).
2) CD. input.
3) Tuner input.
4) DVD input.
5) Tape input (PLAY)
(1)
.
6) Tape output (REC)
(1)
.
7) BYPASS input.
8) Preamp. outputs (to 1 or 2 power
amplifiers or to a Subwoofer).
9) Switch ON/OFF and general plug
in (with protection fuse).
10) Left speaker output (
+
& ).
11) Right speaker output (
+
& ).
12) Trigger output
(a)
.
17) Headphones jack: speakers outputs are switshed off when a headphone is plugged in.
18) Knob for ON/OFF (by pushing), and sources selection (by rotation).
19) Knob for standby ON, volume and balance setup.
REMOTE CONTROL
USING OF THE BYPASS INPUT
DETAIL OF FUNCTIONS
11 1 2 3 4 5 6 7 8 9 10 12
17 18 19
13 14 15 16
CONNECTING
13) Bluetooth receiver.
15) Optical inputs 1 & 2.
14) Coaxial inputs 1 & 2.
16) USB input (B type).
Optional Digital Board:
(1)
Tape input / output - monitoring loop:
The TAPE function allows the recording of music from any selected source.
You can also activate a permanent monitoring loop as follows: select your source
then hold the TAPE button on the remote control for about 3 seconds. The TAPE
symbol lights up and indicates that the monitoring loop is activated. In this
mode, direct access to the TAPE input is no longer possible.
You can use this mode to insert an equalizer between the TAPE IN and TAPE OUT
sockets.
This function is memorized even if you switch off the device from the mains. To
deactivate this mode, simply hold down the TAPE button on the remote control
again for 3 seconds.
(a)
Trigger output: this output is used to control the switching off/on of any device equipped
with a compatible trigger input (see instructions for use).
Trigger cable must be a Male to Male jack plug 3.5mm (1/8”).
Selection of sources
+
(except BYPASS)
Balance setup (from -9 to +9)
Select
display ON
or OFF
Mute
(1)
Stand-by ON/OFF
BYPASS selection (press 3 sec.)
Direct access to sources
(2)
Non-
functional
keys
Volume
+
& and balance
setup (from 0 to 80)