Instructions/Assembly Guide

ManualsBrandsAtlona ManualsAudioDante Network Audio Interface Sound Card

Installation Guide

AT-GAIN-NET

Dante / AES67 Network Card for AT-GAIN-120

AT-GAIN-NET

The Atlona AT-GAIN-NET is an audio interface card for the Gain 120 (AT-GAIN-120) amplier.

It features an AES67 and Dante™ dual-channel audio bridge, adding the capability to accept two

channels over a network from Atlona OmniStream™ AV encoders, as well as a Dante or AES67-

equipped DSP. The AT-GAIN-NET easily installs into the I/O expansion slot of the Gain 120.

1 x AT-GAIN-NET

1 x Face plate

1 x Installation Guide

Package Contents

Summary of content (4 pages)

PAGE 1
Installation Guide AT-GAIN-NET Dante / AES67 Network Card for AT-GAIN-120 AT-GAIN-NET The Atlona AT-GAIN-NET is an audio interface card for the Gain 120 (AT-GAIN-120) amplifier. It features an AES67 and Dante™ dual-channel audio bridge, adding the capability to accept two channels over a network from Atlona OmniStream™ AV encoders, as well as a Dante or AES67equipped DSP. The AT-GAIN-NET easily installs into the I/O expansion slot of the Gain 120.
PAGE 2
Installation Guide AT-GAIN-NET Network Card Installation WARNING: To prevent the risk of electrocution or electric shock, always disconnect the power cord from the AT-GAIN-120 before installing or removing the AT-GAIN-NET network card. 1. Disconnect the power cord from AT-GAIN-120. 2. Set the AT-GAIN-120 on a flat surface, free of obstructions. Position the AT-GAIN-120 as shown in the picture below.
PAGE 3
120 IN- L: E OD GA AT- Installation Guide M R -9 4. -9 Locate the plastic guides on either side of the expansion slot. -14 -19 -20 2 -2 L SET RE -4 -2 DE -19 -20 2 -2 MO dB T IN GA dB INPU AT-GAIN-NET 20W z 1 0W 60H 12 AC Hz 0VAC 50 2 1 - V 100 40 R: 0-2 PW 22 T OU 0V ING / 10 WIR 70VSS 2 A L C ER T OU G 8 Ω IRIN 4 /S 2 W S A L C R L R 8Ω 4Ω -14 IGG TR IP SET RE -4 -2 V 100 70V UT EO L LIN OG AL AN IN N LA 5.
PAGE 4
Installation Guide AT-GAIN-NET Locate the included AT-GAIN-NET faceplate with the INPUT port and install the faceplate using the screws from Step 2, as shown below. Do not over-tighten the screws using hightorque devices, as this may cause damage to the screws or the faceplate assembly.