V 1.1 Revised 6/22 Threaded PT-1000 Temperature Probe Reads Probe type Range Accuracy Reaction time Body Cable length Cable material Connector Output Life expectancy Temperature Class B platinum, RTD -50˚C to 200˚C +/- (0.3 + (0.005*t)) 90% in 10s Stainless Steel 304 1m (3.
Measurements Cable Length 1 Meter (3.2’) Ø 2.8mm M10 Nut 90mm (3.5”) Ø 8mm 6mm (0.
Specifications Cable length Weight Min cable temp Max cable temp Sensing material Dimensions SMA connector Sterilization Food safe 1 Meter (3.2') 51 grams -50°C 200°C Platinum 6mm x 1m (0.1" x 38.4") Male Chemical / Autoclave Yes Materials Teflon 304 stainless steel Epoxy Titanium Nitride Polyethylene This Temperature probe can be fully submerged in fresh or salt water, up to the SMA connector indefinitely.
NSF/ANSI 51 Compliant Atlas Scientific LLC, hereby certifies that, Threaded PT-1000 Temperature Probe Part # PT-THRD Complies with NSF/ANSI Standard 51 Teflon Polyethylene Titanium Nitride 304 Stainless Steel Teflon NSF-51 Compliant Polyethylene NSF-51 Compliant Titanium Nitride NSF-51 Compliant 304 Stainless Steel NSF-51 Compliant 4 Copyright © Atlas Scientific LLC
Operating principle Unlike any other material, platinums correlation between resistance and temperature seems to be woven into the fabric of the universe. It is for this reason, that the platinum RTD temperature sensor is the industrial standard for temperature measurement. Resistance 78 Nickel Pt Platinum 195.
The PT-1000 temperature probe is a resistance type thermometer. Where PT stands for platinum and 1000 is the measured resistance of the probe at 0˚C in ohms (1k at 0˚C). As the temperature changes the resistance of the platinum changes.
Extending the probe cable length You can extend the cable to greater than 100 meters with no loss of signal. Atlas Scientific has tested up to 300 meters without a problem, however you run the risk of turning your temperature probe into an antennae, picking up noise along the length of your cable. If you want to extend your cable, we recommend that you use proper isolation, such as the Basic EZO TM Inline Voltage Isolator, or Tentacle Shield. Be sure to calibrate your probe with the extended cable.
Probe cleaning Over time the Standard Temperature Probe can become dirty and covered in deposits. Both soft and hard coatings can be removed by lightly brushing around the sensing area.
