Owner’s Manual MWBPT Wireless Belt Pack Transmitter MWBPT UHF 100 Frequency Wireless Belt Pack Transmitter 1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A. Telephone: 800.876.3333 • Fax: 800.765.3435 –1– Specifications are subject to change without notice. AtlasIED.
MWBPT Wireless Belt Pack Transmitter Owner’s Manual Description The AtlasIED MWBPT wireless belt pack transmitter is the ideal choice for a variety of applications ranging from classrooms and conference rooms to lecture halls and live presentations. The MWBPT works with either the MWOEM headset microphone or MWLM lavalier microphone. High and low impedance gain adjustments are included to ensure optimal pickup for a variety of applications.
MWBPT Wireless Belt Pack Transmitter Owner’s Manual Parts and Functions 2 5 6 7 8 1 4 9 2 3 10 11 13 3 12 14 1. Antenna 2. LCD Display 3. Cover Release Button 4. Synchronizing Button 5. Menu Button 6. Setting Button 7. High-impedance Gain Control (GT) 8. Low-impedance Gain Control (MT) 9. Battery Compartment 10. Power Switch 11. Power LED 12. Sensor Area 13. Audio Input Connector 14. Charging Contacts 1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A. Telephone: 800.876.3333 • Fax: 800.765.
MWBPT Wireless Belt Pack Transmitter Owner’s Manual Battery Indicator & Installation The MWBPT belt pack transmitter requires two (2) AA batteries to operate. Open the battery cover using the cover release buttons and insert the batteries into the battery compartment. Note: Batteries contain a corrosive acid that may leak and damage the belt-pack when stored for a long period. Batteries should be removed from the belt-pack before storing for more than four weeks.
MWBPT Wireless Belt Pack Transmitter Owner’s Manual Synchronizing Channels on the Receiver and Transmitter Align infrared areas of the receiver and transmitter within 12" (30cm). < 12" Figure 3 A. Changing the receiver’s channel 1. Press the synchronizing button on the belt pack (Fig 4). 2. The belt pack’s LED will illuminate, indicating the frequency is being transmitted to the receiver and that the receiver is synchronizing channels with the belt pack (Fig 5). Figure 4 Figure 5 B.
MWBPT Wireless Belt Pack Transmitter Owner’s Manual Channel Setting 1. Use MENU button to go to the CHANNEL | FREQUENCY page (Fig 8). 2. Press and hold the SET button for 3 seconds, then the upper-right channel number will flash to allow changes to be made (Fig 9). 3. Press SET / MENU buttons to change the channel number. The frequency will change accordingly (Fig 10). 4. After 3 seconds of selecting a channel, it will be automatically saved (Fig 11). 571.000M 575.000M Figure 8 Figure 9 575.
MWBPT Wireless Belt Pack Transmitter Owner’s Manual Important: Use only NiMH rechargeable batteries when using non-alkaline type batteries. Lithium Ion or other rechargeable batteries are not compatible with the MWBPT. NiMH must be selected when using rechargeable batteries. Never select AKLN (alkaline) when using rechargeable batteries. Incorrect battery selection will cause inaccurate battery information to be displayed. System Frequency Range UHF 566 - 585.
MWBPT Wireless Belt Pack Transmitter Owner’s Manual Limited Warranty All products manufactured by AtlasIED are warranted to the original dealer/installer, industrial or commercial purchaser to be free from defects in material and workmanship and to be in compliance with our published specifications, if any.