UHF RFID READER MODULE RM-100 USA User’s Manual Key Features • ISO 18000-6C(Gen2) protocol support • Dynamic RF output power : -4dBm to +27dBm • Low current to extend battery life • Compact size • Low cost
Introduction and system composition diagram ◈ Introduction ◈ • The RM-100EUROPE is an compact size RFID reader module developed for the embedded reader market, which comprises printers, industrial PDA , and similar devices.
Composition parts Reader module Interface connector cable Antenna User manual 3
Module Description ANT port : connect rf cable to reader module and ANT. RF switch connector : TX, RX test port. VCC GND USB_D+ USB_DTXD RXD VCC : 4.
Operation method ----------(1) ◈ Nesslab RFID Mobile Reader Application v1.0 setting - Program Setting 1. Connect serial data cable (RS-232 to UART) to PC and Reader. 2. Run “ Nesslab RFID Mobile Reader Application v1.0 ” with window XP 3. First, check “ Serial , ISO 1800-6C and COM1 “. 4. Supply 4.0v to module.
Operation method ----------(2) 4. Click “ connect “.
Operation method ----------(3) 5. Cleck “ 확인 “ 6.
Operation method ----------(4) - Program Setting 1. The channel setting operation 1) If the frequency hopping ON/OFF check box is checked, set the frequency hopping ON/OFF check box unchecked. 2) Write the channel number to the CH NUM box. 3) Click “ SET “ , then the channel setting is completed 4) If you click “ Multi Read “ the module read the tags at the channel which you check. 5) The tag data is displayed at the Result box.
Operation method ----------(4) 2. The normal operation 1) If the frequency hopping ON/OFF check box is unchecked, set the frequency hopping ON/OFF check box checked. 2) If you click “ Multi Read “, the module read the tags. 3) The tag data is displayed at the Result box.
Channel Table CHANNEL NO FREQUENCY CHANNEL NO FREQUENCY CHANNEL NO FREQUENCY 1 910.2 MHz 21 914.2 MHz 41 918.2 MHz 2 910.4 MHz 22 914.4 MHz 42 918.4 MHz 3 910.6 MHz 23 914.6 MHz 43 918.6 MHz 4 910.8 MHz 24 914.8 MHz 44 918.8 MHz 5 911.0 MHz 25 915.0 MHz 45 919.0 MHz 6 911.2 MHz 26 915.2 MHz 46 919.2 MHz 7 911.4 MHz 27 915.4 MHz 47 919.4 MHz 8 911.6 MHz 28 915.6 MHz 48 919.6 MHz 9 911.8 MHz 29 915.8 MHz 49 919.8 MHz 10 912.0MHz 30 916.
- Additional Page Cautions Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance Information This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received. Including interference that may cause undesired operation.
