User's Guide

5900 NW 86
TH
Street • Suite 300 • Johnston, IA 50131 • 515.288.3360 • www.athenagtx.com
Athena-GTX, Inc. addendum
FCC ID: 2AVRK-XBS6BTH is configured in a specific singular modular use configuration, this addendum is
created to support changes. Information in this addendum is designed to replace FCC publication
996369 related information on Digi XBee Wi-Fi RF Module User Guide Rev W, except where specifically
stated.
Refence Digi XBee Wi-Fi RF Module User Guide Rev W, or greater for additional user guide information.
FCC publication 996369 related information
In publication 996369 section D03, the FCC requires information concerning a module to be presented
by OEM manufacturers. This section assists in answering or fulfilling these requirements.
2.1 General
No requirements are associated with this section.
2.2 List of applicable FCC rules
This module conforms to FCC Part 15.247.
2.3 Summarize the specific operational use conditions
For the XBee Wi-Fi RF Module, see FCC approved antenna (2.4 GHz) identified in section 2.7 of this
addendum.
Once integrated with the Host Device, the Wi-Fi module will communicate (TX/RX) using 2.4 GHz at a
low power (39.81mW), low duty cycle (<1%) while simultaneously a co-located BLE module
communicates (TX/RX) with accessory devices. Modules will be in portable use, <20 cm proximity to
user’s body.
Users are not permitted to modify antenna or alter pre-defined Host or Module configuration settings,
outside of connecting and disconnect other devices.
BLE modules authorized to be used in co-location with XBee Wi-Fi RF Module identified above are, FCC
IDs: 2AA9B04, 2AA9B05.
2.4 Limited module procedures
Not applicable.
2.5 Trace antenna designs
Not applicable.
2.6 RF exposure considerations
Module was reviewed for portable and co-location use. RF exposure has been completed, see report in
FCC registration database.
2.7 Antennas
Only P/N: A24-QI monopole (Integrated Whip) antenna is approved to be used for this module.