User Manual

Copyright (C) ATBS Technology Co. R2.0 版權所有請勿翻印
iTPMSystem for iPod, iPhone, iPad User’s Guide
1. Introduction
This Tire Pressure Monitoring System (TPMS) was
designed for increasing security, reliability, and
understanding on tire conditions of your car. Once you
properly install the TPMS, these sensors will
automatically monitor pressures and temperatures of tires
in real time, and send these data to Receiver through
Bluetooth communications. When there is any abnormal
pressure (under or over inflated) and/or temperature of
tire detected, iPhone, iPod, and iPad will alert driver
immediately. This system could ensure you are driving in
safety.
About This Manual
 The information in this manual is subject to change
without notice.
 This manual has been created with extra care. In
case that you have any comments or questions
regarding this manual, please contact your local
dealer or our Customer Service Center.
 Before operating this set, please fully understand
the prerequisite such as specifications or
constraints of the hardware and software. We are
not responsible and have no liability for any loss,
damage or injury as a result of misuse.
2. Check Accessories
Part Photo Qty
Power adaptor
(12 to 5V)
1
Receiver
BT6000i
1
AT68 sensor 4
Lock Nut Refer to 3.2.3 4
Tool Refer to 3.2.3 1
User Guide 1
Velcro 1
3. Installation
3.1 Install Receiver ：
：：
：
3.1.1 Plug in power adaptor.
3.1.2 Plug in USB connector of power adaptor.
3.1.3 Use velcro to fix receiver.
3.1.4 The LED of receiver will be flashing once it gets
sensor’s signal.
NOTE: Do not make antenna curved
OK NG
3.2 Install AT68 Sensor:
3.2.1 Install battery into sensor and tighten
sensor top cap:
Note: Be sure that the battery polarity was correct.
3.2.2 Check Sensor location:
FL: Front Left tyre, FR: Front Right Tyre
RL: Rear Left tyre, RR: Rear Right Tyre