User's Manual

AT69T User’s manual www.atbs.com.tw

Application:

Installation the Sensor

1-1.Install battery into sensor and tighten sensor top cap.

1-2.Check Sensor ID:

Each sensor should be assigned a unique identification

number (ID).

1-3.Remove original valve cap and screw lock nut first

then sensor onto valve stem.

1-4.Sensor onto valve stem

1-5.Screw lock nut back and using Wrenches to lock tight. This prevents sensor

from easy removing also in favor of sensor stationary.

PAGE 1
AT69T User’s manual www.atbs.com.tw Application: Installation the Sensor 1-1.Install battery into sensor and tighten sensor top cap. 1-2.Check Sensor ID: Each sensor should be assigned a unique identification number (ID). 1-3.Remove original valve cap and screw lock nut first then sensor onto valve stem. 1-4.Sensor onto valve stem 1-5.Screw lock nut back and using Wrenches to lock tight. This prevents sensor from easy removing also in favor of sensor stationary. Copyright (C) ATBS Technology Co.
PAGE 2
Federal Communication Commission Interference StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.