User Manual

ManualsBrandsAT&T ManualsHeadphonesTL7610

Frequently asked questions

Will not pair to base (How to register headset):

Ensure you have a compatible AT&T phone system. Visit DECT 6.0 Compatibility for a

list of compatible systems. Also, ensure that your cordless phone system has the

capacity for an additional handset or headset.

First, you will need to de-register the cordless headset from its base:

Step 1: On the cordless headset base, press and hold PAIR, until the MUTE light starts

to flash. This takes about 10 seconds. Note: The headset can be either in or out of the

charge cradle.

Step 2: Once the MUTE light begins flashing, release the PAIR button, then immediately

press and release it again. Soon, the ON/OFF light on the headset will flash every five

seconds to confirm that de-registration was successful.

Now you can register the cordless headset to your compatible AT&TDECT 6.0 cordless

telephone system:

Step 1: Ensure that the cordless headset is in the charge cradle. On the cordless

telephone base, press and hold HANDSET LOCATOR, until the IN USE light comes on.

Step 2: Immediately release the HANDSET LOCATOR button.

Soon, the ON/OFF light on the headset will illuminate to confirm thatregistration was

successful.

If registration is not successful by the time the IN USE light goes out, lift the headset

from its charge cradle. After a few seconds, return the headset to its charge position,

and try the registration process again.

NOTE: Once the TL7610 headset is registered to the phone system, the controls on the

cordless headset base become inoperative.

Summary of content (4 pages)

PAGE 1
Frequently asked questions Will not pair to base (How to register headset): Ensure you have a compatible AT&T phone system. Visit DECT 6.0 Compatibility for a list of compatible systems. Also, ensure that your cordless phone system has the capacity for an additional handset or headset. First, you will need to de-register the cordless headset from its base: Step 1: On the cordless headset base, press and hold PAIR, until the MUTE light starts to flash. This takes about 10 seconds.
PAGE 2
Will not charge properly & battery compartment top is loose/doesn’t shut properly: 1. Confirm proper installation of the headset base power supply and headset battery. You should only use the AT&T power supply provided with your cordless headset. Make sure the electrical outlet is working and not controlled by a wall switch. 2. Dirty charge contacts on the telephone base and headset could prevent the battery pack from charging.
PAGE 3
getting dial tone at any of your jacks, contact your telephone service provider. If you do not have a different phone for line testing, take your phone to a different location, such as a friends or neighbors home, and test it there. If the problem persists, there may be a malfunction with the unit. 3. Confirm proper installation of the headset base power supply and headset battery. You should only use the AT&T power supply provided with your cordless headset.
PAGE 4
telephone base. Step 5: Plug a telephone line cord into the telephone jack on the corded telephone base. Step 6: Plug the other end of the telephone line cord into your telephone wall jack. If you are a DSL internet subscriber, make sure you have a DSL filter plugged into the wall jack first 6. Ensure you have set the lifter mode correctly. If you are using a handset lifter (models TL7000 & TL7100), press MODE on the headset base until the red indicator next to LIFTER MODE is illuminated.