User's Manual

Using your Wireless Car Charger
1.
Unscrew the large socket nut and
push vent clip ball joint into the
hole until it snaps into place.
2.
Screw the socket nut back on until
tight – this locks the vent clip onto
the wireless charging pad and holds
the adjustable support base in place.
3.
Insert the USB-A plug into the car
charger, then insert the USB-C plug
into the wireless car charger.
4.
VENT MOUNT Attach the mount by
placing the vent clip bracket onto
an air vent in your car and lock the
mount by pressing down on the lever.
NOTE: The lever has two settings. 1 is for thin vents,
2 is for thicker vents. If vent clip does not
feel secure, adjust setting accordingly.
5.
Plug the car charger into the cigarette
lighter socket to power on. The LED
light on the wireless pad will be green
when powered on.
6.
Place your phone on the charging
pad with the bottom of your phone
resting on the support base, and the
arms will automatically close and
hold your phone in place.
NOTE: Adjust the support base accordingly to
ensure best charging position depending
on your device.
7.
To remove your phone, touch the
button on either side of the mount
and the arms will open automatically.
SUCTION MOUNT Attach the suction
mount by placing the it onto the
dashboard or window in your car
and lock the mount by pressing
down on the lever.
Wireless Car Charger
with Vent Mount and
Suction Mount
User Manual
CAUTION:
Wireless charging works with
ONLY Qi-enabled devices.
210 mm x 90 mm, double side printed (Outside)299C K100