Installation Instructions

ManualsBrandsAt Road ManualsElectronicsInternet Location Modem

FCC ID: PDCILM272XSW 6/19/02 DRAFT

Confidential Information 1 PN: 900-002x-000

@Road

@Road @Road

@Road

LMLM







2720 Installation Guide

2720 Installation Guide 2720 Installation Guide

2720 Installation Guide

Important

Important Important

Important –

––

– Please Read!

Please Read! Please Read!

Please Read!

FCC Compliance

This device complies with part 15 of the FCC rules Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

FCC RF Exposure Information

Warning:

The antenna supplied with this device must be used for installation and operation.

Substitution of other antennas must be approved by the manufacturer for compliance to

radiation safety limits, which the antenna gain should not exceed 8 dBi for Cellular Band and

5 dBi for PCS Band. The mounting of this device and antenna must be done by professional

installers to ensure that the user or nearby persons will maintain at least 20 cm from the

antenna in normal use.

Cautions:

All persons must be at least 20 cm from modem antenna when transmitter

operating to meet FCC RF exposure requirements

BEFORE THE INSTALLATION

¾Gather Components

Please ensure you have the following items are together before beginning the installation.

There should be one complete set for each vehicle being installed. If any items are

missing, contact a local Agent or @Road immediately.

LM Unit

Following the simple steps below will ensure optimum

performance of your

LM unit.

Should you have questions, please contact

@Road Customer Service toll-free at

1-877-4-AtRoad (1-877-428-7623).

Summary of content (9 pages)

PAGE 1
FCC ID: PDCILM272XSW 6/19/02 DRAFT @Road iLM LM LM2720 Installation Guide Important – Please Read! Following the simple steps below will ensure optimum performance of your iLM unit. Should you have questions, please contact @Road Customer Service toll-free at 1-877-4-AtRoad (1-877-428-7623).
PAGE 2
FCC ID: PDCILM272XSW DRAFT 6/19/02 2. Power Cable 3. Installation Parts Kit 4. One of Three Antenna options, o Option A: separate GPS and CDMA “on glass” antenna o Option B: one-piece permanent roof mount antenna o Option C: Limo/Lip mount: one-piece trunk lip mount antenna 5. Installation Information Sheet, 3 part carbon (packaged with iLM Unit) ¾ BEFORE YOU CONTINUE Verify/Match Unit to Correct Vehicle NOTE: Some iLM’s are pre-matched to vehicle by number.
PAGE 3
FCC ID: PDCILM272XSW 6/19/02 DRAFT BEGINNING THE INSTALLATION 1) Choose a Location Determine the best location to install the iLM unit.
PAGE 4
FCC ID: PDCILM272XSW 6/19/02 DRAFT Use a voltmeter to verify voltage and hook wires as indicated below. Ground Black to vehicle battery, unswitched (+), this wire must Red (fused, 3 Amps) see at least 10 volts at all times, if not the unit will reset continually and send inaccurate information White (fused, 3 Amps) To true ignition, 12V switched, there must be 12 volt power in the “on”, “start”, and “run” position.
PAGE 5
FCC ID: PDCILM272XSW (A) BEST – Top of the vehicle and as close to the front as possible 6/19/02 DRAFT (B) OPTION – Middle of the roof NOTE: THIS POSITION NOT RECOMMENDED (due to restricted sky view) 5) Connect CDMA Antenna (if separate CDMA antenna or non nonon-combo antenna) The CDMA antenna should be installed in an optimum location, to intercept the cellular signals, arriving at slightly above zero degrees from the horizon.
PAGE 6
FCC ID: PDCILM272XSW STEP 11: 6/19/02 DRAFT The vehicle or equipment must be outside, with a clear and unobstructed view of the sky, away from tall buildings that may interfere with the units GPS reception is also best. STEP 22: STEP 33: • Plug in the power connector and turn the unit on. Once the unit is ON, all four lights should be lit in the following order: ACTIVE LIGHT The Active Light will start blinking within 6 seconds, indicating the unit is functioning properly.
PAGE 7
FCC ID: PDCILM272XSW DRAFT 6/19/02 (2) SOLID – A solidly lit GPS light indicates the unit is working properly. • DATA LIGHT – The Status of this light will vary as this light may light periodically when data is being transmitted between the iLM and the server. Please refer to the following chart. DATA LIGHT Light is off This indicates there is no data in the buffer to be sent to the server, if this light is off it is o.k., it means that there is no data being stored or sent by the iLM.
PAGE 8
FCC ID: PDCILM272XSW 6/19/02 DRAFT followed by SEND. The screen will timeout back to the INBOX after 15 minutes to prevent the unit being accidentally left in this mode. Information on the installer screen The installer screen is designed to present the most important information in a clear, easy to follow format. If you have feedback on the presentation of the screen then please pass this back to @Road so that the screen information can be improved in future firmware releases.
PAGE 9
FCC ID: PDCILM272XSW • 6/19/02 DRAFT Weak signal : The modem is not registered and has a weak signal. This is most likely due to being in an area of poor coverage, but may indicate a problem with the CDMA antenna or the IP address. The iLM will not transmit or receive data in this state so @Road customer satisfaction should be contacted. GPS Status values The GPS status comprises a description, followed by a number (0-8) and a letter A or B in brackets.