User Guide for NUC12SNK[x] Intel® NUC 12 Enthusiast Kit NUC12SNKi72 User Guide 1
User Guide for NUC12SNK[x] Before You Begin CAUTIONS The steps in this guide assume you’re familiar with computer terminology and with the safety practices and regulatory compliance required for using and modifying computer equipment. Disconnect the computer from its power source and from any network before performing any of the steps described in this guide.
User Guide for NUC12SNK[x] This guide tells you how to: • • • • • • Install and remove memory Install an M.2 SSD Install a VESA mount bracket Connect power Install an operating system Install the latest drivers Open the Chassis To open the Intel NUC chassis, follow these steps: 1. Unscrew the six corner screws on the bottom cover of the chassis and lift the cover.
User Guide for NUC12SNK[x] Installing and Removing Memory Intel NUC Kits NUC12SNKi72 have two 260-pin DDR4 SO-DIMM sockets. Be sure to select memory modules that meet these requirements: • • • 1.2V low voltage memory 3200 MHz SO-DIMMs Non-ECC Find compatible memory modules in the Intel Product Compatibility Tool • NOTE NUC12SNKi72 If you plan to install only one memory module, install it in the lower memory socket. To install memory, follow these steps: 1.
User Guide for NUC12SNK[x] Install an M.2 SSD The Intel NUC Kits NUC12SNKi72 support an 80mm SSD. Find compatible M.2 SSDs in the Intel Product Compatibility Tool • NUC12SNKi72 If you’re installing an 80mm M.2 SSD: 1. Remove the small silver screw from the 80mm (A) metal standoff on the motherboard. 2. Align the small notch at the bottom edge of the M.2 card with the key in the connector. 3. Insert the bottom edge of the M.2 card into the connector (B). 4.
User Guide for NUC12SNK[x] Close the Chassis After all components have been installed, close the Intel NUC chassis. Intel recommends this be done by hand with a screwdriver to avoid over-tightening and possibly damaging the screws.
User Guide for NUC12SNK[x] Attach and Use the VESA Bracket (Optional) Follow these instructions to attach and use the VESA mount bracket: 1. Remove VESA bracket from the default stand. 2. Using the four small black screws that were included in the box, attach the VESA bracket to the back of the monitor or TV 3. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.
User Guide for NUC12SNK[x] 4. Slide the Intel NUC onto the VESA mount bracket.
User Guide for NUC12SNK[x] Connect Power Country-specific power cords are included in the Intel NUC Kit box. Connect AC power Each Intel NUC model includes either a region-specific AC power cord or no AC power cord (only the power adapter). 9 Product codes RNUC12SNKi72000 Power cord type No power cord included. An AC power cord needs to be purchased separately. Power cords are available at many Internet sites for use in multiple countries. The connector on the power adapter is a C5 type connector.
User Guide for NUC12SNK[x] Install an Operating System Refer to Supported Operating Systems for a list of Intel-validated Windows* operating systems and versions of Linux that have been reported as compatible by Intel NUC owners. Refer to Operating System Installation for system requirements and installation steps.