User Manual

Click!
outer rail
➊
inner rail
➊ Key Hole ①⑤-
➋ Screw Hole
Ⓐ-M4X4L
Pull tab forward and
take out inner rail.
Copyright © 2022 King Slide. All Rights Reserved
Electronic File
Click!
①
②
③
④
⑤
 Make sure the spec of rack hole and find the suitable pins from accessory bag.
#6-32x4L
M5X20L-P0.8
(For #10-32)
Screw Hole Pin
(For Ø7.1)
Round Hole Pin
M4x4L-0.7P
Screw Sack
Rear BracketFront Bracket
Ⓑ
Ⓒ
Ⓑ
Ⓒ
Ⓐ
Ⓑ
Ⓒ
Ⓓ
Ⓔ
➊
Pull
➋
➌
➊
Rear Bracket
➌
Front Bracket
➍
➌
➎
➏
Click!
Click!
➊
➋
➌➍
➎
CAUTION! Verify ball bearing retainer is locked forward.
Horizontally install system half way into slide rail.
Tighten chassis with thumb screw.
Slide the blue release tab and push system into rack.
➋
For9.5 Square Hole
1) Release and detach the inner member from the slide.
2) Attach inner member to the system.
Please press according to arrow
direction,and slide the
intermediate member back.
➌
➍
➎
Install the inner member
onto the chassis by this
direction.
 For safety concern, user
canfastenthescrewonthe
end of inner rail while
assembling on the chassis.
3) Attach outer member to the rack.
ⒶⒺor
Rear Bracket
Front Bracket
Extened Nut.For Shipping
Ⓕ
Ⓖ
Ⓖ
Ⓖ
Pre-installed
When using in 9.5mm square hole, install 2 pcs screw and 1pc screw on the front
bracket 2 pcs screw on the rear bracket.；
ⒼⒻ
Ⓖ
Ⓔ-
#6-32x4L
Ⓖ
Ⓕ
➍
4)
When using in Ø7.1 round hole rack, please remove
all the screws on the front and rear brackets. Replace
Please choose A or E screw
for inner rail depends on
chassic spec.
➊
Pull
➋
➊
➌
➍
➎
➏
Rear Bracket
Front Bracket
them by screw .Ⓑ
Click!
➊
➋
PullWhite
➎
locking
➊➋➌➍➎➏
Square Hole
Round Hole
➊➋➌➍➎➏
Blue
➌
R
Detach inner rail from standoff
①
Ⓔ-#6-32x4L
Ⓐ-M4X4L
③
②
Detach Rear Bracket From Rack Post
Detach Rear Bracket From Rack Post
➌
①
②
Pull
➊
➌
④
③
Pull