Rail Kit Installation Manual ESC8000 Series E12613 / First Edition / March 2017
1. Rail kit installation 1.1 Friction Rail Kit The rail kit package includes: Friction rack rails Front end 1.2 Rack rails Rear end Attaching the rack rails To install the Friction Rail Kit: 1. Select a 3U space on the rack where you want to install the rack rail. 2. Place the appropriate rack rail (left and right) on opposite positions on the rack. A 1U space is consists of three square mounting holes with two thin lips on the top and the bottom.
. Secure the rail components to the rail using the bundled screws. 4 Press the spring lock ( ) then insert the studs into the selected square mounting holes on the rack post. 5. 6. Press the spring lock on the other end of rail then insert the stud into the mounting hole on the rack post. Extend the rack rail, if necessary. (Optional) Use the rail screw and rail washer ( ) that comes with the kit to secure the rack rail to the rack post. Recommended screw torque is less than 14 kgf.cm 7.
1.3 Mounting the server to the rack • Ensure that the rack rail cabinet and the rack posts are stable and standing firmly on a level surface. • We strongly recommend that at least two able-bodied persons perform the steps described in this guide. • We recommend the use an appropriate lifting tool or device, if necessary. To mount the server into the rack: If you installed the rail screw and rail washer in step 6 of section 1.
2. Rail kit dimensions 43.6mm 900mm 43.
Rail Kit Installation Manual