User Manual

ManualsBrandsAsus ManualsServers & WorkstationsESC4000A-E11

Accessory Content and Usage

Ⓑ

Ⓒ

Rear bracket

 Make sure the spec of rack hole and find the suitable pins from accessory bag.

1) Remove the inner rail.

inner rail

outer rail

Pull tab forward and

take out inner rail.

white

Pull

Click!

➋

➊

➌

Pull the latch

upward and

remove the

keyhole from

standoff.

Detach Inner Rail

from Standoff

①

②②

Click!

➊

Key Hole ①-④

➋

Screw Hole ⓐⓑ-

①

②

③

④

ⓐ

rear bracket

Front bracketFront bracket

rear latch

3) Fix the outer rail / bracket assembly to the frame.

Front bracket

Note:

Please repeat installation step for the

other side.

Square Hole Round Hole

Press

➍

Click!

➎

Click!

➌

Press

➋

➊ Please press the rear bracket before installation.

Rear Bracket

➋

➌

Rear bracket Rear bracket

➊➋➌➍➎ ➊➋➌

Front bracket

➊

Press

Rear Bracket

➌

Detach Backet from Rack Post

➍

Press

4) Insert the chassis to the rack to complete the installation.

➊

➋

➌

Ensure ball bearing retainer is located at the front of the outer rail.

Insert the chassis into outer rails.

Tighten chassis with shipping screws.

Click!

➊

➌

①②

④

Loosen shipping screw to pull out chassis.

Press the disconnect tab forward to remove chassis.

③

①

②

④

③

Ⓒ

➊The default usage of the rail. When using in 9.5mm square rack hole, install 2 pcs screw G and 1pc screw F on the front bracket,

2 pcs screw G on the rear bracket.

➋.When using in 7.1 round hole rack, please remove all the screws on the front and rear brackets Replace them by screw C

➌ .When using in thread hole rack, please remove all the screws on the front and rear brackets Replace them by screw D#10-32

➊

/ⓑ

ⓐ

/ⓑ

➋

➌

➊

➋

➌

➋

If chassis with thumb screw, please use

screw F.If chassis without thumb screw,

no need to use screw F.

➋

Electronic File

Inner rail

For 7.1 Round Hole

For #10-32 Thread Hole

For Shipping

NAME SPEC

SPEC

M4x4L-P0.7

Round Hole pin

#10-32x13L

M5x20-P0.8

#6-32x4L

Front bracket

Screw Sack

ITEM

outer rail

ITEM

Pre-installed

Square Hole Pin

For 9.5 Square Hole

Extened Nut.For Shipping M5x13.5L - P0.8

NAME

Summary of content (1 pages)

PAGE 1
R 1 Accessory Content and Usage Make sure the spec of rack hole and find the suitable pins from accessory bag. ➊ The default usage of the rail. When using in 9.5mm square rack hole, install 2 pcs screw G and 1pc screw F on the front bracket, 2 pcs screw G on the rear bracket. ➋ When using in 7.1 round hole rack, please remove all the screws on the front and rear brackets . Replace them by screw C ➌ When using in #10-32 thread hole rack, please remove all the screws on the front and rear brackets .