User Manual

Highlights: Update BMC FW 2.3.1 and BIOS 0201 and you may
boot up with both Rome and Milan CPU
<BIOS and BMC FW version may vary by different models
Please note update BMC firmware from 1.0 or 2.0 series to the
BMC 2.2 series via WebGUI is not workable. If you want to update
from BMC 1.0 or 2.0 series to BMC 2.2 series
please use FLASH1.BAT or FLASH2.BAT >
1. Use Rome CPU to boot up.
* If no Rome CPU, please install each one of the supported CPUs
and plug in the power cable. The BMC LED will light up once the
on-board BMC is active. Please go to router/switch to get DHCP
to assign IP to login WEBUI.
Rome to Milan Dual BIOS update SOP
<ex.>