OccupEye® User Manual Revision 2.
Contents Introduction ................................................................................................................ 3 Installation and Commissioning .................................................................................. 4 Operation ................................................................................................................... 5 Disposal and Replacement of Batteries .....................................................................
Introduction OccupEye is a wireless workspace utilisation system that enables users to capture and analyse true occupancy data accurate to the second. The OccupEye sensor is an intelligent device and comprises fully integrated passive infra‐red sensor, radio transceiver with antenna, microprocessor and data storage memory. OccupEye sensors are lightweight, compact and portable, allowing for flexible deployment in monitoring individual workspace utilisation and/or room utilisation.
Installation and Commissioning The OccupEye system is professionally installed and commissioned ready for use. The user can recommission the OccupEye system using the OccupEye Interface software. To commission a new OccupEye sensor run the OccupEye Interface software, select the required OccupEye host and click the [Auto Commission] button. If required, load settings from a file or change the sensor address number in field next to the [Auto Commission] button. Insert batteries into the sensor.
Operation The OccupEye Interface software manages the OccupEye hosts and OccupEye sensors and captures the transmitted occupancy data into log files. When connected to the internet the log files are forwarded to the OccupEye Dashboard hosted analytics software. The sensor will also store occupancy data in its memory if the OccupEye host network is disconnected or the OccupEye Interface software is not running.
Disposal and Replacement of Batteries Please dispose of, or recycle batteries in accordance with the environmental regulations that are applicable in your location. The batteries in the OccupEye sensor should be replaced with AA, Alkaline batteries.
General Specifications OccupEye Sensor Operating Temperature: Operating voltage: 0 to 35 degrees Celsius 3V (2 AA Batteries) or 5V USB OccupEye Host Operating Temperature: Operating voltage: Operating Current: Page 7 of 10 0 to 35 degrees Celsius 5V USB 0.
Support For support please email support@occupeye.com For software and documentation please visit www.occupeye.com OccupEye® is a registered trademark of OccupEye ltd. Copyright © 2018 OccupEye ltd.
FCC Warning Statement FCC ID: 2ARNWOES02 ‐ OccupEye Sensor Please note that the OccupEye sensor is a low power device and a SAR exclusion calculation was applied which means the device can operate in close proximity to the user’s body. FCC ID: 2ARNWOEH02 ‐ OccupEye Host Please note that the OccupEye host is a low power device but it should not be within 20cm of the user’s body when switched on. The following statement applies to both devices This device complies with Part 15 of the FCC Rules.
ISED Warning Statement IC: 24506-OES02 ‐ OccupEye Sensor This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. IC: 24506-OEH02 ‐ OccupEye Host This device complies with Industry Canada license-exempt RSS standard(s).