User's Manual

Cord‐FreeKitforWiiNunchuk 
Version: 2.0 2008‐01‐18Page12of18
7. User Guide
7.1． User Explain
Connect the Wii Remote with the receiver and the Wii Remote with the Console, also connect the
receiver with the Wii Nunchuk and installed the battery according to the instructions
At this time the transmitter will be in sleep mode, press the comb key to wake up transmitter, the
transmitter into the search mode, Status LED flashes to 2 Hz, and then wait for the receiver to connect with
the transmitter, if any receiver is in connection mode, transmitter and the receiver will be reset identification
ID and confirmed to use of other channel connection (registration), After the wireless Transmitter is
connected it will register with the receiver ,and the transmitter Status LED flashes with the 1hz. Transmitter
and receiver will turn into data transfer mode.
7.1．1. With the transmitter press the Comb Key to awaken the transmitter, the transmitter then
will go into the search mode, the transmitter status LED will flash 2 Hz.
7.1．2. When the receiver is in the search mode, the receiver connection led will flash 2 Hz.
7.1．3. Wireless receiver and transmitter complete re-configuration identification ID and
confirmed the completion channel connecting lines.