User's Manual

ManualsBrandsAsoka In ManualsElectronics"KAMA" WIRELESS CONTROLLER FOR WII

User Manual

Connect the Wii Remote with the receiver and the Wii Remote with the

Console, also connect the receiver with the Wii Nunchuk and installed the

battery according to the instructions.At this point emission end sleep

mode, to comb the key first press the transmitter, launcher wake-on-to

enter the search pattern, Status LED to 2 Flash, then wait for a connection

with sink, sink if there is any one in the wiring of status, launcher and

stay connected sink will reset identification ID and confirm to connect by

using other channels (registered), when you have completed wireless

connections through transmit and receive-side (registration), the Launcher

Status LED times. Transmitter and receiver into data transmission status.

With the transmitter press the Comb Key to awaken the transmitter, the

transmitter then will go into the search mode , the transmitter status LED

will flash 2 Hz. When the receiver is in the search mode, the receiver

connection led will flash 2 Hz. As following:

Summary of content (5 pages)

PAGE 1
User Manual Connect the Wii Remote with the receiver and the Wii Remote with the Console, also connect the receiver with the Wii Nunchuk and installed the battery according to the instructions.
PAGE 2
PAGE 3
Connection status： Online status of the Transmitter break the connection： When the receiver and the Transmitter has been in connection line status, if connection is cut, the Transmitter will return into the search mode, Connection LED will flash with 1 Hz, Transmitter connected or press comb key again, the receiver and the transmitter can be connected again.
PAGE 4
receiver, transmitter will go into sleep status. If the transmitter goes into search mode press the button to connect Comb model line, then the receiving end with the completion of connecting lines. Receiver in the search mode of connection methods： Receiver into the search mode, Connect LED flashes to 2 Hz, at this time, if more than two-transmitters are entered, the registration or connecting line mode, the receiver will be complete registration with any Transmitter which it has not Connected.
PAGE 5
Battery low voltage detect： Because the transmitter uses the battery the reason, has established the low pressure examination electric circuit in the launcher interior, when two battery voltages are lower than 1.8V time launcher Status LED dodges quickly under the active status by the 4HZ speed, instructed the battery voltage is somewhat low, needs to replace the battery. FCC NOTE: This device complies with Part 15 of the FCC Rules.