Installation Instructions

Installation Instructions:
Warning: Please make sure the power is off before installation.
1. Turn off the power switch.
2. Screw off the CFL or MHL or HPS and so on, see Figure (5)(6).
3. Take out led corn light and screw on, see Figure (1)(2)(3)(4).
Figure (1)(2) (3) (4):AC internal driver,
(Note: Pls make sure to take off the ballast before installing led corn light,
otherwise the ballast will produce the resonance of high voltage and makes
led corn light breakdown.)
4.If security rope provided, pls fix the rope on the lamp with hand,
then fix the wire of other end on the shell, see Figure(2) (4).
5.Lamp CCT and dimming can be adjusted after removing the
top plastic cover with a screwdriver. Figure(5) (8)
6. Turn on the power switch.( Finished!)
Figure(6)
Figure(3) Figure(2) Figure(1) Figure(4)
Security Rope
Buckle on the lamp
1.ROTATE
2.PUSH
L
N
1.ROTATE
2.PUSH
3.TIGHTEN
Security Rope
1
2
3
1
2
3
Figure(5)
1
2
3
1
2
3
4
Figure(7)
-3-
1
2
CCT adjustable and dimming mode diagram：
1.Continuous dimming
Sensor interface
Single CCT
27-63W
Single CCT80-120W
Single CCT
27-63W
Single CCT80-120W-S
80W 100W 120W
36W 45W 54W
SWITCH DIM
DIMMING KNOB
Figure(8)
with 0-10V continuous
dimming function
0
120W
100W
80W
0
27W
18W
12W
-4-
27W 12W 18W 27W
36W 18W 27W 36W
45W 27W 36W 45W
54W 36W 45W 54W
63W 36W 54W 63W
80W 54W 63W 80W
100W 63W 80W 100W
120W 80W 100W 120W
Rated
wattage
Dimming mode
2.Segmented dimming
A0
◆ Single CCT mode, without CCT adjustable function.
◆Two dimming options are available for the Single CCT mode 27-120W,
continuous dimming or segmented dimming.
◆Can be with Clear or frosted PC cover.
◆Single CCT 27-120W lamp can be with AC100-277V internal driver.
◆Motion sensor or PIR sensor are optional for the Single CCT mode 80-120W.
◆12-120W Sealant pouring for whole drive and lamp plastic housing.
◆Long lifespan and good heat dissipation. No fan.
◆Direct replacement for Metal Halide, easy Installation.
◆Fits many different fixtures to replace traditional lamps.