Dear Customer, Thank you for choosing this quality product from ASKO. We hope it will meet your expectations and fulfil your needs for many years to come. Scandinavian design combines clean lines, everyday functionality and high quality. These are key characteristics of all our products and the reason they are greatly appreciated throughout the world. To get the most from your new dishwasher, we recommend that you read the operating instructions before using the dishwasher.
Contents Front panel Safety instructions Before washing for the first time Loading the dishwasher Using the dishwasher Settings 2 3 4 4 6 9 Care and cleaning Troubleshooting Technical information Installation Service Program chart 11 13 16 18 22 23 Front panel To start the machine, press and hold the main power switch until the display lights up.
Safety instructions General • Read the operating instructions and keep them in a safe place! • Never use the dishwasher for any purpose other than that specified in these operating instructions. • Do not load the dishwasher door or dishwasher baskets with anything other than dishes. • Never leave the dishwasher door open as someone may trip on it.
Before washing for the first time Loading the dishwasher Checking water hardness Economic dishwashing Contact the local water utility to check the water hardness in your area. This is important with regard to how much detergent and rinse aid to use. Run programs only with a full load Wait to run a program until the dishwasher is full. This way you save energy. Use the Rinse & Hold program to rinse the dishes if there are any unpleasant odours while you wait for the dishwasher to become fully loaded.
The dishwasher's baskets The dishwasher is equipped with a top cutlery tray, an upper basket and a lower basket with cutlery basket. Top cutlery tray The top cutlery tray has space for cutlery, ladles, whisks, serving cutlery and similar items. Raising the top cutlery tray 1 Pull out the top cutlery tray. 2 Pull the two locking handles on either side forward to raise the top cutlery tray. Lower basket Lowering the top cutlery tray 1 Pull out the top cutlery tray.
Using the dishwasher Washing large plates Move the foldable tines and their mounts to widen the distance between the tine rows to adapt the lower basket to plates with a diameter greater than 25 cm. Add detergent Cutlery basket Place cutlery with the handles facing down, except for knives, and spread them out as much as possible. Ensure that spoons do not stack inside each other.
Daily wash A program suitable for day-to-day dishwashing. This program can also clean dried leftovers, but is not intended for burnt food, such as on oven dishes. High temperature Activate this option for improved dishwashing results. The machine then uses a higher temperature for the main wash. This option cannot be activated if the Time saver option is selected. If you want to use the lower temperature, press until the field next to the button turns off.
Time remaining Do you want to add more dishes? Once you have selected a program and options, the display indicates how long the program took the last time it was used. Once you have started the dishwasher, the display indicates how much program time remains. The remaining time is updated after the water for the final rinse has been heated. Open the door. The dishwasher stops automatically. Add the dishes, close the door and the dishwasher continues the program.
Settings Do as follows to open the settings menu: Button press Description 1. Turn off the dishwasher using the main power switch. Wait about five seconds. Then press the main power switch again. Wait until the numbers appear in the right-hand display before continuing to the next step. 2. + Within five seconds, press and hold the Program selector (wait for the audible signal confirming the button press) and then immediately press the Long dry button without releasing the Program selector.
Button press Options Settings Description Press Start/Stop to save the setting value and continue to the next setting. (Off) Operation volume This sound is used to confirm each button press. (Low) (High) Press Start/Stop to save the setting value and continue to the next setting. (Low) LCD contrast For adjusting the contrast of the display. (High) Press Start/Stop to save the setting value and continue to the next setting.
Care and cleaning Coarse filter NOTE! The coarse filter traps larger food particles, which cannot get past the drainage pump. Empty the coarse filter as necessary. The dishwasher must not be used without the filter in place! 1 Lift the coarse filter by the handle. 2 Empty the coarse filter. Remember to replace it! Coarse filter Diswashing efficiency can be affected if the course filter is incorrectly fitted.
Door When cleaning the edge around the door, use only a slightly damp cloth (with a little cleaner if necessary). WARNING! Do not use a spray bottle or the like around the door lock. This is to ensure that water does not penetrate the door catch and come into contact with the electrical components. Lower spray arm • Pull the lower spray arm straight up to release it. Upper spray arm • The upper basket must be removed before the upper spray arm can be released.
Troubleshooting Display Type of fault Action Overfilling Call the service division. Water outlet fault See "Water remains in the dishwasher" in the table below. Water inlet fault Check that the water tap is on. Check whether dishwasher inlet hose is connected to a pressure limiting valve (some pressure limiting valves may restrict the supply of water to the dishwasher). Inlet valve leakage Turn off the water tap and call the service division.
Problem Possible causes Action Rattling sound when dishwashing. The dishes are not correctly placed or the spray arms are not rotating. Check that the dishes are placed securely. Spin the spray arms to make sure they can rotate. The dishwasher does not start. The Start/Stop start button has not been pressed for long enough. Press and hold Start/Stop until the display flashes three times with the remaining time. The door is not properly closed. Check. A fuse/circuit breaker has been tripped.
Problem Possible causes Action The touch buttons do not react when pressed. You have pressed the touch buttons too soon Wait a moment then try again. after opening the door. Dirt on the touch buttons. Clean with a dry or slightly damp cloth. Child lock (button lock) activated. See the section Settings.
Technical information Information for test institute Energy labelling Australian standard: AS/NZS 2007 Number of place settings: 14 Dishwashing programs: Normal program; Low temperature, Short dry (no options) The door should be opened upon completion of the drying cycle a distance of 35 mm at V. V Program time: 2:20 hours:minutes Connection: Cold water 20 °C Test method for noise measurement: IEC 60704-2-3 Dosages during testing Detergent: In accordance with AS/NZS 2007 Prewash: 7.
Technical data Height: 817-872 mm Width: 596 mm Depth: 550 mm Weight: 49 kg 1) Capacity: 14 Place settings 2) Water pressure: 0.03–1.0 MPa 0.3–10 kp/cm2 3–100 N/cm2 Electrical connection: See type plate. Rated power: 1) 2) See type plate. Weight can vary due to different specifications. In accordance with standard, AS/NZS 2007.
Installation 1189 [mm] 550 596 133-183 49 700 670 821 -872 717 519 30 30-94 *Remove locking nuts for an installed height of 820-821 mm. Safety instructions Transport protection for the door • Connections to electricity, water and drainage must be performed by a qualified professional. • • Always follow applicable regulations for water, drainage and electricity.
Suggested machine installations The dishwasher can be installed built-in, completely freestanding or partially built-in. A. Built-in The dishwasher is intended for installation under a worktop. The recess dimensions are illustrated. Holes for wires/cables need not be larger than 38 mm in diameter. Make sure the edges of such holes are even to prevent damage to the drainage and inlet hoses and the power cable. [mm] C.
The drainage hose may be extended by a maximum of 3 m (the total length of the drainage hose must not exceed 4.5 m). Any joins and connecting pipes must have an internal diameter of at least 14 mm. However, the drainage hose should ideally be replaced with a new hose without joins. No part of the drainage hose may be more than 950 mm above the bottom of the dishwasher. The hose must not be routed directly to a floor drain or the like. In such cases, the hose can act as a siphon and empty the dishwasher.
Adjusting the plinth (only when using toe kick accessory) Set the correct plinth depth as follows * (Not applicable to all models) The dishwasher is supplied with one or two toe kicks depending on the model. The table shows which toe kick you should use depending on the recess height and plinth depth.
Service Read chapter Troubleshooting before contacting the service department. Note down the details on the rating plate positioned on the right inside the dishwasher. Note down the item number (1) and serial number (2). 4. 1 ART. NO. SERIAL NO. 2 5. x x 6.
Connection to hot water, approx. 60 °C. The energy label performance figures are based on this program. 4) 0.01 0.5-1.6 0.8 0.73 1.5 1.3 Connection to cold water, approx. 20 °C. 0:06 0:15-2:30 2:30 2:20 3:15 2:25 0:06 0:15-2:30 2:15 2:05 3:00 2:10 1) 0.01 0.4-1.2 0.5 0.4 1.0 0.7 Energy (approx. kWh) Hot water 3) Energy Dishwashing (approx. kWh) time (approx. hrs:min) 3) --- °C max. 65 °C 50 °C 45 °C 60 °C 65 °C Dishwashing time (approx.
Quick guide Load the baskets 1. (See page 4.) Do not rinse dishes under running water before loading them in the dishwasher. Simply scrape off large food particles before loading the dishwasher. Check that the spray arms can rotate freely 2. Check also that the water tap is on. Add detergent 3. The detergent compartment has one smaller compartment for the prewash and one for the main wash. (See page 6.) Press the main power switch and close the door 4. Check/Add rinse aid 5.