User's Manual

Page15/25

Installation procedure for connecting to the Ethernet interface
Follow these steps for proper installation. Plug the coaxial cable to the cable wall outlet and the other end to
the modem connector labeled "CABLE".
Note:Toensureafastregistrationofthemodem,thecoaxialcablemustbeconnectedtothemodem
beforeitispoweredon.
Plug the power supply into the socket of the cable modem and two-pin on the adatper plug into the AC outlet.
Note:Onlyusethepowersupplythatcomeswiththemodem. Usinganotherpowersupplycancause
damagetotheproduct,andwillvoidthewarranty.
Connect an Ethernet cable (direct connection, see below) to the Ethernet port at the back of the computer,
and the other end to the ETHERNET port on the rear panel of the cable modem. The modem will seek the
appropriate cable signal on the cable television network and go through the initial registration process on its
own. The modem is ready for data transfer after the green LED "ONLINE" is lit continuously.
Note:thebutton"reset"atthebackofthemodemisusedprimarilyformaintenance. 
Fig. 1-7 Connect to the Modem