Quick Start Guide asi.
Welcome 1. System description 2. LED Behaviors 3. Quick Start 4. Charging 5. Conductive shirt – care and sizes 6. Warnings asi.
Network status Device status Turn on/off Serial number Charging slot Electrocardiogram electrodes Docking Station Pod Slot Heart rate meter Charging slot asi.
LED Behaviors Blinking red Blinking green Blinking blue Steady red Steady green Steady blue Device status Network status Device status Battery charge complete Battery charging Starting / sensors initialization Recording in progress Low battery / Firmware update in progress Shutdown / Memory full / other hardware issue Network status Start-up/config Searching network Connected to network, connecting to server Connected to server, sending data to server OTA update in progress Network error asi.
Quick start SWITCH ON/OFF THE DEVICE On: Press the button until a green light turn-on. Off: Press the button three consecutive times, the information LED turns red and then turns off STARTING PROCEDURE To get GPS/GNSS satellites, make sure it is open sky Make sure both LEDs are blinking green You are ready to go asi.
Charging AdMosLive has an autonomy ranging between 5 and 10 hours depending on the configuration Full charging of the battery can take up Device to 1,5status hour LED behavior in charging mode Battery charge complete Battery charging WITH DOCKING STATION Make sure the devices are correctly set to the docking station Power the docking station with the provided plus WITH MANETIC USB-CABLE asi.
Conductive shirt Sizes To ensure the best quality of ECG signal, the shirt size must be aligned with the athlete's chest size. The size must be measured under the pectorals (same position as the belt strap). Recommended lifetime of the shirt of 100 usages Care asi.
Warnings Use AdMosLive only as directed in the user manual. Do not disassemble the device. Protect the device from possible damage, do not drop or expose to extreme heat of excessive sun exposure. Keep the device in a clean and dry place, at room temperature. Avoid scratching the device. Protect the AdMosLive from water. asi.
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 5mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.