Installation Guide
PRELIMINARY
INSTALLATION GUIDE
Wireless Pull Cord Module (NUWPC3–Hx) Mounting
7. Adjust the length of the cord:
• Lift the bottom barrel of the cord (item 1).
• Cut the cord about 2.5cm (1 in) below the desired length (item 2).
• Tie a double knot at the end of the cord by looping the end of the cord twice through the loop (item 3).
• Pull the knot tightly (item 4).
2.3 Placing of batteries
1. • Open the battery door of the base (item 1).
• Remove the battery pack from the base (item 2). The battery pack is kept in place by a small edge. Lift
the pack over this edge.
2. Place 2 x 1.5V AA disposable Alkaline batteries (not included) in the battery pack, pay attention to the
polarity of the batteries.
TD 93427EN / 30 October 2020 / Ver. PA4 6