IP-DECT Access Point/ Base Station Safety and Regulatory Instructions
English Safety Instructions Read these instructions before installing the equipment. For safe and efficient operation of the equipment, observe these instructions and all necessary safety precautions when using the equipment. Follow the installation instructions and adhere to all warnings and safety precautions located on the product, and product manuals.
• Ensure the AC receptacle is installed near the equipment and easily accessible. • When mounting the equipment on a wall, use fasteners supplied with the system. • Position the electrical cord to the AC power supply where it is least likely to be subjected to damage or stress. • Remove the electrical cord from an outlet by pulling gently on the AC adapter, not by pulling the cord. Regulatory Compliance Statements (EU/EFTA only) This equipment is intended to be used in the whole EU & EFTA.
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Modifications Changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Exposure to radio frequency signals This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
PM000035B Ver.