User Manual

ManualsBrandsAscion ManualsElectronicsCustom Memory Remote Control

RC-WM-101 Controller

Model: RC-WM-101

FCC ID. :

THIS DEVICE COMPLIES WITH PART 15 OF THE

FCCRULES. OPERATIONS IS SUBJECT TO THE

FOLLOWING TWO CONDITIONS: ( 1 ) THIS DEVICE

MAY NOT CAUSE HARMFUL INTERFERENCE AND

( 2 ) THIS DEVICE MUST ACCEPT ANY INTERFERENCE

RECEIVED, INCLUDING INTERFEERENCE THAT MAY

CAUSE UNDESRIED OPERATION

VFKRC-WM-101

Summary of content (5 pages)

PAGE 1
RC-WM-101 Controller Model: RC-WM-101 FCC ID. : VFKRC-WM-101 THIS DEVICE COMPLIES WITH PART 15 OF THE FCCRULES.
PAGE 2
Power supply: Use 4 X AAA 1.5V Battery (6V) Description: The hand control will have an RF transmission, with a range of 9 feet (3 meters). The RF transmission will have a “key code” to give each remote a unique transmission signal. It will have raised rubber buttons that will have the ability to be backlit when pressed. The hand control will have an ergonomic design and will use 4 AAA batteries.
PAGE 3
Custom Memory Recall Button “CUSTOM #1” • When pressed, it will recall the memory position #1 of the head and foot lift motor positions from the memory. • When held for 3 seconds it sets the custom position at the bed’ s current position to memory position #1. • LED lights up when initiated. • Backlight initiates and it lights up all buttons. • Upper Backlight LEDs and RF LED indicator h 3 times when memory is saved.
PAGE 4
Foot Vibration Motor Button “-” • When pressed, it will initiate the Foot vibration motor and when pressed again it will decrease the intensity. • It will start at the 50% intensity level of a standard vibration. • It should have a total of 10 intensities. • MUST press vibration “ STOP” before changing wave intensity/mode. • LED lights up when initiated. • Backlight initiates and it lights up all buttons.
PAGE 5
Wave Vibration Motor Button “Wave 4 ” • When pressed once, it will initiate the Head and Foot vibration motors to the “ Wave #4” vibration mode. • It will start at the 50% intensity level. • Wave 4 represents the alternating vibration from head to foot in 4 second intervals. • Press and hold again for 3 seconds and it will shut off all vibration, • MUST press vibration “ STOP” before changing wave intensity/mode. • LED lights up when initiated. • Backlight initiates and it lights up all buttons.