Operating Instructions CARSHARING ZUSATZKARTENLESER ASAP Electronics GmbH Original instructions Edition EN 2020/07
Safexpert Project Data: Project designation: Project number: Order: CARSHARING ZUSATZKARTENLESER ZKL PRJ-2020-05-08-0001 Trade name: CARSHARING ZUSATZKARTENLESER Product name: CARSHARING ZUSATZKARTENLESER Serial number: from 1001 Machine number: Model: Type: Manufacturer: ASAP Electronics GmbH PO box: Sachsstraße 1A DE 85080 Gaimersheim Ph. +49.8458.3389-0 Fax +49.8458.3389-599 electronics@asap.de www.asap.de Revision index: 1.
Regarding this Operating Instructions 1 Table of Contents 1 Regarding this Operating Instructions ............................................... 5 1.1 General .................................................................................................. 5 1.2 Signs and symbols used ........................................................................ 5 1.3 Design of warnings ................................................................................ 6 1.
1 Regarding this Operating Instructions 6.2 Switching the ZKL on ........................................................................... 14 6.3 Switching the ZKL off ........................................................................... 14 7 Help in case of faults ......................................................................... 15 7.1 Procedures for faults or errors.............................................................. 15 7.2 Fault and error messages .....................
Regarding this Operating Instructions 1 1 Regarding this Operating Instructions Before operating the CARSHARING ZUSATZKARTENLESER for the first time or if you are authorized with other tasks on the CARSHARING ZUSATZKARTENLESER, you have to read these Operating Instructions. In particular, observe chapter 2 „General Safety Regulations“. 1.
1 Regarding this Operating Instructions 1.3 Design of warnings Warning levels Signal word Used for … Possible consequences if the safety note is not being observed: DANGER Personal injuries (imminent threat) Death or serious injury! WARNING Personal injuries (possible dangerous situation) Death or serious injury! CAUTION Personal injuries Minor injuries! Tab. 1.
General Safety Regulations 2 2 General Safety Regulations 2.1 Principles The ZKL must only be operate in perfect technical condition. 2.2 Intended use The ZKL enables to read card identification (IDs) numbers and broadcasting them via BLE to the vehicle. 2.3 2.
2 General Safety Regulations For commissioning and during operation CAUTION! Lithium battery CR123A The CR123A lithium battery used inside the ZKL is not rechargeable. Only the CR123A lithium battery type may be used Structural changes Structural changes (electrical / mechanical) are not permitted. 2.5 Measures in an emergency Fire fighting 8/22 Edition EN 2020/07 In the event of a fire, the system must be extinguished with a CO2 fire extinguisher.
Scope of supply 3 3 Scope of supply CARSHARING ZUSATZKARTENLESER Adhesive tapes Operating instructions The battery CR123A is not part of the scope of supply! Fig. 3.1 ZKL Fig. 3.
4 Technical description 4 Technical description 4.1 Overview Function description The ZKL will initiate the reading of the card identification (IDs) numbers, if the state of the card detections has changed. The state changes, when a card is inserted or removed. The ZKL is sending a BLE broadcast periodically to the vehicle. The broadcast contains the manufacture specify data with the BLE MAC address of the module, the battery state and the card IDs of the detected cards.
Technical description 4 4.2 Card slots Fig. 4.1 Card slots 4.3 Type label Fig. 4.
5 Installation and commissioning 5 Installation and commissioning 5.1 Commissioning Following steps, only be carried out by the service technician. Push the locking clips inwards and lift the top shell lightly – fig. 5.1 Housing is now open – fig 5.2 Remove the upper shell Remove the PCB from the lower shell.
Installation and commissioning 5 Fig. 5.2 Open housing Fig. 5.
6 Operating ZKL 6 Operating ZKL 6.1 ZKL - Modes 6.2 No card is detected One card is detected Two cards are detected Switching the ZKL on Look at commissioning 6.
Help in case of faults 7 7 Help in case of faults 7.1 Procedures for faults or errors Check if an undefined card was used Check if card is in the slot up to the fixed stop 7.2 Fault and error messages Please contact service! 7.3 Removing faults Remove and insert the card again If the fault or error message continues to occur, please contact service.
8 Decommissioning and disassembly 8 Decommissioning and disassembly 8.1 Disposal and recycling Make sure that plastic sleeves, packaging, are recycled correctly. Do not just throw these materials away. This product is subject to the European Directive 2012/19 / EU. Dispose of the product through an approved waste disposal company or at your local waste facility. Observe the regulations applicable in your country. If in doubt, contact your waste disposal facility.
Technical data 9 9 Technical data Designation Value Unit Mass 0,096 kg Max. operating temperature 70 °C Min. operating temperature -25 °C Lithium battery (Power supply) Model code CR123A Nominal voltage 3,0 V Nominal capacity 1400 mAh Power consumption 0,033 W Operating time without service ≥ 30 month Acoustic output, dB(A) N/A Normal operation condition RFID and BT mode Tab. 9.
10 Appendix 10 Appendix 10.
Appendix 10 Edition EN 2020/07 CARSHARING ZUSATZKARTENLESER Operating Instructions 19/22
10 Appendix 10.2 FCC statement Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Appendix 10 10.3 IC statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
Sachsstraße 1A DE 85080 Gaimersheim Telefon +49.8458.3389-0 Telefax +49.8458.3389-599 E-Mail electronics@asap.de Subject to technical changes EN 2020/07 ASAP Electronics GmbH ASAP Electronics GmbH reserves the right to change this documentation and the descriptions, dimensions and technical data it contains without prior notice. ASAP Electronics GmbH does not assume any responsibility for possible errors in this documentation.