User's Manual

ManualsBrandsASAHI DENSO ManualsElectronicsSteering Lock

User Manual

Handsfree-System

The document hereon is the property of Asahi Denso Co., Ltd.

Page 5 of 23

CL9_UserManual_V02.docx

1. Overview

This product is an electric steering lock with Handsfree-System designed to prevent theft.

The system is composed of:

- The steering lock referred to as Main Unit (1), which provides the following functions:

⚫ User recognizer, by means of an Active Transponder (2) or a Passive Transponder (3).

⚫ Lock and Unlock of the steering, by moving the Lock bar (5).

⚫ Enable and disable of the ignition of the bike.

- The smart key referred to as Active Transponder (2). It can also be used as an RFID transponder.

- The RFID transponder referred to as Passive Transponder (3).

- Antenna Unit (4)

The Handsfree-System combines the transponder functionality (LF: Low Frequency) and the radio controller

transmission (RF: Radio Frequency) to recognize the right user of the motorcycle.

The Handsfree-System can manage the Fuel Tank Cap (6)'s open/close state.

The system is integrated in CAN bus for all data transfer with the other electronic units on the motorcycle.

(1)

(5)

(7)

(6)

(4)

(3)

(2)

Summary of content (10 pages)

PAGE 1
User Manual Handsfree-System 1. Overview This product is an electric steering lock with Handsfree-System designed to prevent theft. The system is composed of: - The steering lock referred to as Main Unit (1), which provides the following functions: ⚫ User recognizer, by means of an Active Transponder (2) or a Passive Transponder (3). ⚫ Lock and Unlock of the steering, by moving the Lock bar (5). ⚫ Enable and disable of the ignition of the bike. - The smart key referred to as Active Transponder (2).
PAGE 2
User Manual Handsfree-System Key ON (Unlocking of the steering) Active Transponder User recognition with the active transponder (2) is performed as described below: A. Press the Lock-Unlock-Button (7) on the handlebar of the motorcycle less than 1.5 second. B. The Main unit (1) requires the transponder (2) for a radio frequency identification with an LF signal transmitted by the Antenna Unit (4). C. If the active transponder (2) is within a range of 1.
PAGE 3
User Manual Handsfree-System Replacing the battery in the Active transponder (A) (B) [Important] Take special care (A) when removing the key battery. This symbol (B) warns the user about important use and maintenance instructions contained inside the documents provided with the equipment. [Warnings / Caution] Risk of battery leakage, heat generation, and explosion ・ Do not expose the key to high temperatures, such as on the dashboard, and under direct sunlight.
PAGE 4
User Manual Handsfree-System 1. Insert ②"screwdriver" into the dent of ①"Rear plastic cover". Raise the inserted ②"screwdriver" in the direction of the arrow and remove ①"Rear plastic cover". ① ② 2. Insert ④"Coin" into the dent in ③"Coin battery cover", turn 90 degrees counterclockwise so that the OPEN position comes to ▽, and remove ③"Coin battery cover". ④ ③ Page 8 of 23 The document hereon is the property of Asahi Denso Co., Ltd. CL9_UserManual_V02.
PAGE 5
User Manual Handsfree-System 3. Remove ⑤"Used coin battery" and replace it with ⑥"New coin battery" . [+] ⑤ [-] [+] ⑥ [-] 4. Attach ③"Coin battery cover" and use ④"Coin" to fix ③"Coin battery cover" by turning 90 degrees clockwise so that the CLOSE position comes to ▽. ④ ③ 5. Attach ①"Rear plastic cover" with hooks in the order of (A) → (B). Page 9 of 23 The document hereon is the property of Asahi Denso Co., Ltd. CL9_UserManual_V02.
PAGE 6
User Manual Handsfree-System (A) (B) Page 10 of 23 The document hereon is the property of Asahi Denso Co., Ltd. CL9_UserManual_V02.
PAGE 7
User Manual Handsfree-System 2. Installation notes Handsfree-System attachment Handsfree-System consists of Main Unit, Active Transponder, Passive Transponder and Antenna Unit. These are attached to a vehicle by factory/field personnel. Access to Active Transponder internal parts It is strictly forbidden to have access to the inner electrical components, except used battery to be replaced.
PAGE 8
User Manual Handsfree-System 3. Technical Specification Steering lock (Main Unit) Parameter Nominal voltage Operating voltage Operating temperature Storage temperature Operating current Sleep current Operating frequency Modulation Frequency channel Data rate RF Power Digital transfer controller operating frequency NOTE MIN NOM MAX UNIT ASK 1 channel - 11.8 8.5 -20 -30 133.8 - 12 134.2 1.6 - 12.2 16.0 +70 +80 5500 100 134.
PAGE 9
User Manual Handsfree-System Label printing position and the date of manufacture Steering lock YY MM DD WW NNNN … … … … … Smart key Year of manufacture Month of manufacture Day of manufacture Week of manufacture (January 1 is the first week) Manufacturing number Page 14 of 23 The document hereon is the property of Asahi Denso Co., Ltd. CL9_UserManual_V02.
PAGE 10
User Manual Handsfree-System FCC(USA) certification Product name Steering lock Smart key FCC ID T8VCL9 T8VCL9-904 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.