Installation Instructions

ManualsBrandsARTIKA ManualsElectronicsStar raker remote

1. Turn off the power at the circuit

breaker and the light switch.

Ensure the power is off before

removing the old light fixture.

2. Partially install the two junction

box screws in the junction box

leaving 1.5 cm distance between

the head of screw and ceiling level

(fig. 1).

3. Connect the white wire (N) from

the light fixture to the white supply

wire (N) from the junction box

using a wire connector. Connect

the black wire (L) from the light

fixture to the black supply wire (L)

from the junction box using a wire

connector. Connect the ground

wire (G) from the light fixture to

the ground supply wire (G) from

the junction box using a wire

Summary of content (6 pages)

PAGE 1
. Turn off the power at the circuit breaker and the light switch. Ensure the power is off before removing the old light fixture. 2. Partially install the two junction box screws in the junction box leaving 1.5 cm distance between the head of screw and ceiling level (fig. 1). 3. Connect the white wire (N) from the light fixture to the white supply wire (N) from the junction box using a wire connector.
PAGE 2
connector (fig. 2). 4. Carefully push the wires into the junction box. Align the holes of the base of the light fixture with the junction box screws, raise the base and turn it counter-clockwise, locking it into place. Fasten the junction box screws, be careful not to overtighten them. The base should be flush with the ceiling (fig. 3).
PAGE 3
5. Ensure all three clips are open 6. Carefully install the diffuser by lifting it into position and locking each clip. Keep holding the diffuser in place until all three clips are locked. (fig. 4). The clip will click when locked.
PAGE 4
7. Restore electrical power.
PAGE 5
8. specification Operating Frequency 5.8 GHz ±75 MHz，ISM Band. Transmitting power 0.03mW Max. FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 6
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.