CM-20 / CM30 Instruction Manual
INSTRUCTION MANUAL MODEL: CM20 (whole set) / CM30 (without wireless headphone) INTRODUCTION & WARNINGS Thank you for purchasing this iPod Universal Docking System with built-in amplifier, wireless speakers & wireless headphone (only available in CM20 system), the result of our advanced state-of-the-art electronic design. To achieve the best results from this product, please read this manual carefully before operating this product. In no circumstances attempt to open this product.
• • • • • power supply in your country is compatible with the voltage rating of the provided power adapter. Use ONLY the provided power adapter. Never use other power adapters even if they have the same specifications or rating. Do not insert or remove the power adapter for the electric outlet with wet or damp hands. Remove the power adapter from the electric outlet if the product is not in use for a long time. When inserting or removing the power adapter from any electric outlet, pull the plug only.
POSITION OF CONTROLS Docking Part A2 B4 A1 B1 A3 A4 B5 B3 B2 A1. Docking (remember to place with your suitable iPod adapter) A2. Antenna A3. Volume Control A4. Power Indicator B1. Power Switch (Off / On plus Amplifier function / On plus Wireless function) B2. 12V DC Power Socket B3. Audio In B4. Audio Out B5.
Wireless Speaker Part C1 C4 C2 C5 C3 C1. Powerful Speaker C2. Antenna C3. Volume Control C4. On/Off Switch C5. DC charger socket C6.
Wireless Headphone Part (Available in CM20 only) D4 D2 D1 D3 D1. On/Off Switch D2. Power LED Indicator D3. Volume Control Switch D4. Battery Compartment (on the Left Headphone) POWER SUPPLY & CONNECTIONS 1. Connect the plug of the provided power adapter to the 12V DC socket of the docking and connect the plug to the electric outlet. 2. Put your iPod into the dock with appropriate adapter, or simply connect your audio source by using the provided audio cable to the “Audio In” of the docking.
NOTE: 1. Always remember to remove the power adapter form the electric outlet when the product is not in use. 2. This device will automatically switch-off when there are no audio signals for about 1 minute. OPERATION For Normal Audio Mode: 1. Connect the speakers to Audio Out socket 2. Place your Music iPod onto the docking and switch on your device to AF mode 3. Use the functions key to select the appropriate action 4. Enjoy your music. For Wireless Mode: 1.
MAINTENANCE The system is maintenance-free. opened, the warranty is voided. Therefore never open it if the system is Check the technical safety of the system and the connected units regularly for damaged cable or housing. If it becomes probable that a risk-free operation is no longer possible, take the system out of operation and secure it against unwilling operation in the following cases a risk free operation becomes improbable: • The system is visibly damaged.
Playback on only one channel: • The balance control on the audio source is not set correctly. • The iPod is not plugged correctly Playback noise • The range of the transmitter has been exceeded. • There is a metal barrier between the transmitter and receiver ( i.e. a steel reinforced concrete wall). • Disturbance by other radio emitters (cordless telephone, computer, microwave oven etc.). Find another position for the system or the disturbing unit respectively.
• • apparatus The mains plug or the appliance coupler shall always remain readily operable. Take attention to the environmental aspects of battery disposal. FCC statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
49.86MHZ one channel only.