RFID reader writer NEX5000S(LCP) Users Manual Ver1.00 ART Finex Co.,Ltd.
■ About Attention receive matters For regulations and standards This product has built-in inductive read / write communication equipment. Ask of the time of your use The quality level of this product is limited to general applications (computer , OA equipment , FA equipment , communication equipment , measuring equipment , AV equipment, etc.
Copyright Software of this product , including the Convention on the copyright laws and , if the law on other intellectual property rights ①This product software reverse engineering , you will not be able to decompile or disassemble , . ② It is not possible to modify the whole or any part of the product of the software . Precautions for Safe Use This product has been designed with safety in full consideration .
( If the following matters are ignored, and there is incorrect handling , it may cause a malfunction) ●Do not store or use at the location ( environment ) , such as the following . ●outdoors or in direct sunlight ●locations subject to vibration and shock ●moisture and dust in many places ●violent place or places where condensation occurs of location or temperature, and there is a humidity difference between high-temperature and high- humidity ●close to the ones generated by the heat ( stove , heater , etc.
Contains Transmitter Module FCC ID: 2AM8PNEX5000SLCP Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure). Page 5 of 8 ART Finex Co., Ltd.
1. Overview This document describes the hardware specifications and the function outline of the RFID reader / writer "NEX5000S(LCP)". NEX5000S(LCP) is an RFID reader / writer with a UART interface. NEX5000S (LCP) is an embedded module. When actually using it, it is necessary to prepare an interface board, control board, etc. separately. When using, cover the product with a resin case etc. so that your hands and fingers do not touch the product. 1-1.Feature (1) Hardware ① It implements the UART interface.
2.Hardware Specifications 2-1.Body specification № 1 2 3 4 Item Name of product Communication system Carrier frequency Radio Law division 5 Host interface 6 7 8 9 10 Power supply Consumption current Operation temperature Storage temperature Storage and operating humidity Housing size (D × W × H) DC5.0V±0.
2-2.Body Photo Reader/Writer module Antenna (TOP view) (Bottom view) 2-3.How to install Use the holes at the four corners of the board to install the board with screws. If there is a metal plate around the antenna board, the reading performance may be affected. Install the antenna board and the metal plate at a sufficient distance. Page 8 of 8 ART Finex Co., Ltd.