User's Manual

ASI4000R2X
Product Code: ASK3668
ASI4000 Series Electromagnetic Inductive RFID System
13.56MHz RFID Reader/Writer Module
User Manual
Revision1.0 – 5 Nov. 2019
Pg.1
Since this module is not sold to general end users directly there is no user manual of module.
For the details about this module, please refer to the specification sheet of module.
This module should be installed in the host device according to installation procedure.
Following informationes must be indicated on the host device manual of this module.
Contains FCC ID: 2AM8P-3668
Contains IC: 7805A-3668
This device complies with part 15 of FCC Rules and Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'appareil doit accepter tout brouillage subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Following information must be indicated on the host device of this module.
This is the label drawing example placed on the host device.
Contains FCC ID: 2AM8P-3668 Contains IC: 7805A-3668
This device complies with part 15 of FCC Rules and Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.