Certification Exhibit FCC ID: UID2402GCT IC: 6670A-2402GCT FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-210 ACS Project Number: 12-0437 Manufacturer: Arris International, Inc. Model: MG2402G/CT Manual 5015 B.U.
Touchstone® MG2402G/CT Media Gateway User’s Guide The Touchstone MG2402G/CT Media Gateway enables all TV and DVR, telephony and data service in the home, through Hybrid Fiber Coax (HFC) access network using DOCSIS RF interface standards.
Export Regulations This product may not be exported outside the U.S. and Canada without U.S. Department of Commerce, Bureau of Export Administration authorization. Any export or re-export by the purchaser, directly or indirectly, in contravention of U.S. Export Administration Regulation is prohibited. Copyright © 2013 ARRIS. All rights reserved. The information in this document is subject to change without notice.
Safety Requirements ARRIS Media Gateways comply with the applicable requirements for performance, construction, labeling, and information when used as outlined below: CAUTION Risk of shock Mains voltages inside this unit. No user serviceable parts inside. Refer service to qualified personnel only! CAUTION Potential equipment damage Potential loss of service Connecting the Media Gateway to existing telephone wiring should only be performed by a professional installer.
• Do not use the telephone to report a gas leak in the vicinity of the leak. • The product shall be cleaned using only a damp, lint-free, cloth. No solvents or cleaning agents shall be used. • Do not use spray cleaners or aerosols on the gateway. • Avoid using and/or connecting the equipment during an electrical storm, to avoid risk of electrocution. • Do not locate the equipment within 6 feet (1.9 m) of a flame or ignition source (i.e. heat registers, space heaters, fireplaces, etc.).
• Do not mount the Media Gateway on surfaces that are sensitive to heat and/or which may be damaged by the heat generated by the modem, its power supply, or other accessories. FCC Part 15 This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation.
Industry Canada Compliance Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Touchstone® MG2402G/CT Media Gateway User’s Guide Copyright © 2013 ARRIS. All rights reserved. The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations in this document are believed to be accurate and reliable, but are presented without express or implied warranty. Users must take full responsibility for their applications of any products specified in this document. The information in this document is proprietary to ARRIS.