User's Manual

Menu display allows to go deeper to

the SETTINGS mode, MEASuring

mode or to SERVICE mode.

Press SETTING button.

We are in the settings mode again, but

with little difference in INFO part.

Scroll to INFO and press SET.

New button is visible – SET Umain.

Press it.

Type of supported TCVR and

working

frequency are visible on the

display.

AUTO LED is ON.

Type of supported TCVR and

working

frequency are visible on the

display.

AUTO LED is ON.

Type of supported TCVR and

working

frequency are visible on the

display.

AUTO LED is ON.

PAGE 1
MenuType display allows to go deeper to of supported TCVR and the SETTINGS mode, working MEASuring mode or to SERVICE mode. frequency are visible on the display. Press SETTING button. AUTO LED is ON. We are in of thesupported settings mode Type TCVRagain, and but with little difference in INFOworking part. frequency are visible on the display. Scroll to INFO and press SET. AUTO LED is ON. Type of supported TCVR and New button is visible – SETworking Umain. Press it. frequency are visible on the display.
PAGE 2
TypeType proper value ofTCVR the and primary of supported voltage and press ENT. working Press frequency EXIT twice go back to the aretovisible on the Menu display. display. AUTO LED is ON. This means not programmable setting of the primary voltage. It is just information for the processor, which protects the permitted limits ( up or down) for a given value of the primary voltage (protection circuit). MEAS pressing shows this screen.