User's Manual

16
You selected IC7800 addr.6AH and
19200 Bd. Press SET to write to the
memory, then press EXIT to go back to
the SETTINGS possibilities.
“SET OTHER ADDRESS” means that
you must add here a new type of used
ICOM TCVR which is not defined in the
table (its address plus bitrate in Bd) to
have possibility to communicate with it.
Touch ANTENNA SETTINGS. First
select ANTENNA SWITCH (No switch,
Standard). Use left or right arrows. If
you select some switch, 10 ports for
different antennas displays. Generally
all of antennas are allowed in every
band (green squares). To disable some
square select port (up/down), touch
SET for antenna name and then select
band (left/right). Touch SET.
Four types of antenna for four different
bands were disabled.
Black square means disabled
combination.
Press EXIT to go back to SETTINGS
menu.
BCD code (4 bits) is using for automatic antenna and BPF switching (see Antenna/BPF
connector on the Control panel (rear side of the PA).
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.