User's Manual

Use left/right button to set 20mA or as

close as possible value and press

SAVE.

Similar ways EBS2 can be

preprogrammed (250mA).

Scroll to CALIBRATION Ip, Is and

press SET. Calibration will be done

automatically.

Go to the bottom line.

This feature allows user to switch OFF

the SWR protection.

We recommend to set it ON (SWR

protection circuit will stay active, max.

allowed SWR is 3:1). If OFF is

selected, higher SWR is allowed, but

reflected power is measured. If it

exceeds 350W, transmit will be

blocked.

Press EXIT.

Type of supported TCVR and

working

frequency are visible on the

display.

AUTO LED is ON.

Type of supported TCVR and

working

frequency are visible on the

display.

AUTO LED is ON.

Type of supported TCVR and

working

frequency are visible on the

display.

AUTO LED is ON.

PAGE 1
Use left/right button to set 20mA Type of supported TCVR andor as close as possible valueworking and press SAVE. frequency are visible on the display. Similar ways EBS2 can preprogrammed (250mA). AUTO LED is ON. be ScrollType to of CALIBRATION Ip,and Is and supported TCVR press SET. Calibration will be working done automatically. frequency are visible on the Go to the bottom line. display. AUTO LED is ON. This feature allows user to switch OFF the SWR protection.
PAGE 2
5.4. Operation mode Before switching to operation mode, check all connections between PA and TCVR. We are back in the Main display, Type of supported TCVR and bar graphs were defined, antennas working were preprogrammed, CAT was set. We are frequency visible on the ready to go to theare operation mode. display. Press shortly black STBY/OPER button on the front panel. AUTO LED is ON. We are in the operation TCVR mode. and Type of supported Press MENU. working frequency are visible on the display.