Quick Start Guide 1
What’s Included Welcome Base station Base station power adapter Ethernet cable Magnetic wall mounts Mounting screws Thank you for choosing Arlo. Getting started is easy.
1 Get the App For the best experience, download the Arlo app for your smartphone by scanning this QR code or searching for Arlo in the app store. 2 Connect Your Base Station to the Internet a. Connect the base station to your router using an Ethernet cable. b. Connect the AC adapter to your base station and plug it in. arlo.netgear.
3 c. Turn the base station on by pressing the On-Off button. The Power LED and Internet LED on the front of the base station light green in about two minutes. Get an Account ¾¾ To create a new Arlo account: a. Launch the Arlo app from your smartphone, tap the New to Arlo? button, and select Arlo Wire-Free. If you are using a computer, visit arlo.netgear.com. b. Follow the onscreen instructions. ¾¾ To add an Arlo Pro camera to an existing Arlo account: a.
4 Insert Batteries Into Your Cameras a. Unlock the battery compartment by sliding and holding the latch. c. Insert two batteries near the back of the camera. d. Insert two batteries near the compartment hinge. 5 e. Close the battery door. Sync Your Cameras With the Base Station Note: Cameras must be synced one at a time. a. Bring the camera within 1 to 3 feet (30 to 100 centimeters) of the base station. b. Slide the battery door back and lift it to open the compartment.
b. Press the Sync button on the side of the base station for about two seconds. Release the button. c. Wait for the Sync Status LED to blink green. 10 d. Press the Sync button on top of the camera for about two seconds. Release the button. A blue LED on the camera blinks slowly when the sync process starts. The blue LED blinks rapidly to confirm sync. Syncing more than one camera? Go to page 9 and repeat steps 5a through 5d for each camera. The camera is ready for viewing.
6 Place or Mount Your Cameras Locate a spot for your camera To mount your camera to the wall: You can place your camera on a shelf or other flat surface, or you can mount it to the wall. Fasten the mounting screw into the wall, and hang the magnetic mount from the screw. Tip: Use the Arlo app in Position mode (found in Camera Settings) to help aim the camera. If you’re mounting the camera to drywall, be sure to use the plastic drywall anchors that are provided.
You’re Done! Base Station LED Guide Congratulations! Your Arlo System is set up and ready to go. To view useful tutorial videos, find troubleshooting tips, or get support, visit arlo.com/support/. Reserved for upcoming features 14 Power Internet Camera Green The base station is powered on. Green The base station is connected to the Internet. Green Cameras are connected to the base station. Blinking green A firmware update is in progress. DO NOT TURN OFF BASE STATION OR CAMERAS.
©NETGEAR, Inc., NETGEAR, the NETGEAR Logo, and Arlo are trademarks of NETGEAR, Inc. Compliance For the current EU Declaration of Conformity, visit http://kb.netgear.com/app/answers/detail/a_id/11621/. For regulatory compliance information, visit http://www.netgear.com/about/regulatory/.