Installation Guide
1. PACKAGE CONTENTS
2. TOOLS YOU MAY NEED
Screwdriver Pencil Drill/drill bits Measuring Tape
a. Inside, Ceiling or Flush Mounts
(A minimum 1 inch depth is required or 1-3/4 inch depth for flush mounts.)
b. Wall or Outside Mounts
(A minimum 1-1/2 inch flat wall space is necessary.)
3. DETERMINE INSIDE/CEILING, FLUSH, WALL OR OUTSIDE MOUNT
1. Test the location for the end mounting bracket 1 to 6 inches from
the end of each headrail side. Position each mounting brackets so
that there is no interference with the cords and mechanisms inside
the headrail.
2. For wider shades that require 3 or 4 brackets, position the
mounting brackets so that they are spaced evenly between the two
outermost mounting brackets.
3. Mark the mounting bracket locations upward through the holes with
a pencil (ensure that the position of the mounting bracket's release
tab is facing downward).
4. Use the 1-1/4 inch screws to anchor in the (pencil marked) top
bracket holes to firmly attach the mounting brackets to the surface.
1. Test the location for the end mounting bracket 1 to 6 inches from
the end of each headrail side. Position each mounting brackets so
that the
re is no interference with the cords and mechanisms inside
the headrail.
2. For wider shades that require 3 or 4 brackets, position the
mounting brackets so that they are spaced evenly between the two
outermost mounting brackets.
3. Mark the mounting bracket locations towards the back, rear holes
with a pencil (ensure that the position of the mounting bracket's
release tab is facing downward).
4. Use the 1-1/4 inch screws to anchor in the (pencil marked) rear
bracket holes to firmly attach the mounting brackets to the surface.
Up to 60 inch 3 2
Up to 72 inch 4 2
Shade Width Mounting Brackets Quantity Handle Quantity
Up to 48 inch 2 1
CORDLESS FABRIC ROMAN SHADE
INSTALLATION INSTRUCTIONS
RELEASE TAB
a. INSIDE OR CEILING MOUNTS
b. WALL OR OUTSIDE MOUNTS
RELEASE TAB
Mounng
Brackets
Shade
1-1/4 inch
Screws & Anchors
Handle