Use and Care Manual

■ Know Your Shade
Number of parts included for each shade:
Shade
Width
Brackets
Hold-
down
Bracket
Headrail
end caps
Bottom
rail end
caps
Handle
Larger
Screws
(Bracket)
Smaller
Screws
(Hold-
down
Bracket)
W ≤ 38" 2 2 2 2 1 4 4
W > 38" 3 2 2 2 2 6 4
- Bracket
- Hex head screw
- Handle
- Headrail end caps
Left side: Right Side:
- Bottom rail end caps
- 1/2 inch screws
- Hold down brackets
■ Prepping the Shade
Install the left and right headrail end caps by sliding both top
tabs into the top of the headrail.
Left Side: Right Side:
To install the bottom rail left and right end caps, match the flat
side of the end caps with the bottom rail of your shade (For
bottom rail end caps, left/right side are the same). Using the
flat surface on the end caps, push fabric/stiffener against the
end of the rail and slide the end caps into the side of the rail.
Left Side: Right Side:
■ Outside Mount
(A minimum 3/4" flat wall space is necessary.)
Position brackets above window opening. Remember to leave
the brackets a few inches away from each side of your window.
Spread them out evenly by measuring the same distance from
each side of the window.
Make sure brackets are aligned. “L” shape opening should be
facing down, with the shorter side against the wall.
Insert 2 of the hex head screws into both openings and fasten.
■ Inside Mount
(A minimum 1" depth is required or 2-inch depth for flush
mounts.)
Position brackets along the top of the window opening in the
desired location. Remember to leave a few inches from each
side of your window.
Make sure both brackets are aligned. “L” shape opening
should be facing down, with longer side against top of the
window opening.
Insert 1 hex head screw into the oval opening, between the
two springs, and fasten.
DO NOT use hex head screws for holes on the back of the
bracket for inside mount. It will prevent your shade from
clicking in place. These holes can be operated with 2 flat-head
screws (Flat-head screws are not included in the package).
180-889/006