Owner Manual

DIAMOND FIRE RING

Read this manual carefully before using this product and save it for future reference.

  

A Panel 4

T Bolt (M5x10mm) 8

U Washer 16

V Nut 8

Y Wrench 1

Z Poker 1

ASSEMBLY

Tool required for assembly, Wrench (Y), is included.

DO NOT FULLY TIGHTEN THE NUTS & BOLTS BEFORE ASSEMBLING THE ENTIRE RING.

1. Set Panels (A) upright and align the holes on the inside of the panels.

2. Connect the panels by hand-tightening 1x Bolt (T), 2x Washers (U), and 1x Nut (V) on the top of the

panels as shown. Repeat this step on the bottom of the panels.

3. Repeat Steps 1 & 2 until all panels are connected.

4. Tighten all hardware using Wrench (Y).

• Do not discard packaging until you have checked that all parts are accounted for.

• Assemble components on a soft, clean surface to avoid scratching or damaging

the finish.

• Keep children away during assembly. This item contains small parts that can

be swallowed by children.

• Children should always be under direct adult supervision around this product.

Purchase Date: / / Order/Customer Reference Number:

U VT U

T U V

If you have any questions, comments or concerns, feel free to contact us by phone, by email or via our page

Thank you for choosing our Decor. We stand behind our brand and the quality of the items we sell.

Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof of

purchase, with the date of purchase as well as photos of the merchandise defect, must be provided.

Photos are used to determine the cause of defects and for future quality control.

Page 1 / 2

PAGE 1
Purchase Date: / / Order/Customer Reference Number: Thank you for choosing our Decor. We stand behind our brand and the quality of the items we sell. Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof of purchase, with the date of purchase as well as photos of the merchandise defect, must be provided. Photos are used to determine the cause of defects and for future quality control.
PAGE 2
CARING FOR YOUR FIRE RING: Clean Regularly: All fire rings must be cleaned and inspected periodically. The ash produced in fire rings must be cleaned out regularly. Clean Safely: Make sure the fire has completely died down and the metal is completely cool before you remove the ashes. Avoid Accelerants: Never use accelerants to start a fire; this is dangerous and can be damaging the fire ring. Avoid Plastic: Never use any plastic materials in or nearby a fire.