User Manual

Installation Instructions
Install one of Arlington’s low voltage
mounting brackets (not supplied)
at entry and/or exit locations.
Use L
V1
for the single-gang CE1,
and LV2 for the
two-gang CE2.
1 For entry location: Use the
mounting bracket as a
template, and cut hole for
entry location. Feed wires
into the cable entrance
plate. Make sure that the hood is in the desired
orientation; facing in or out.
2 For wire exit: Install low voltage mounting
bracket (repeat above instructions). Fish wires
from behind the wall sur
face and pull through
the bracket. Feed wires into CE1 or CE2 with
the hood in the correct orientation (in or out).
3 Attach both (entry and/or exit) cable entrance
plates to the LV1 or LV2 mounting brackets.
4 Connect wires to electronic equipment.
Catalog
UPC/DEI/NAED
Description
Plate
Unit/Std
Number
Mfg. #018997
Non-metallic Cable Entrance Plate Color
Pkg
CE1 10460 Single gang White 10
CE2 10461 Two gang White 10
Cable Entrance Plates and Hood
Reversible • Non-metallic • Cable protection at its best
NEW!
HOOD on
reverse
1 Stauffer Industrial Park
Scranton, PA 18517
800/233.4717
Fax [phone]
www.aifittings.com
A
A
r
r
l
l
i
i
n
n
g
g
t
t
o
o
n
n
Arlington’s new REVERSIBLE entrance
plate not only protects cable, but
delivers good looks and installation
versatility.
Use it facing IN – or OUT. It’s easy to
install. And, it’s the best way to run
cable where you want it.
• Non-rusting, paintable plastic
• Versatile, easy to use
• Install facing in or out
Includes
screws
that
match
plate
color
CE1
CE2
CE1
w/ plate
facing IN
CE2
w/ plate
facing OUT
See reverse for
Cable Entrance Hood
for decorator plates
LV1
LV2
CE2
w/ plate
facing IN
at
www.aifittings.com
View V
ideo
Patent pending