Installation Guide

ManualsBrandsARK DESIGN ManualsBarn Doors60 in. x 84 in. Paneled Off White Primed MDF British K-Shape MDF Sliding Barn Door with Hardware Kit

Hardware Included



Size

Part

Name

5.5FT

6FT

6.6FT

7FT

Wall Spacer

M0.31x3.54"

Screw

Ø0.39"

Anchor

2 PERSON

ASSEMBLY

UP TO 30 MIN.

ASSEMBLY

Barn Door Hardware

INSTALLATION MANUAL

Rail

HangerX2 M0.39x2.16"

rew

Hex KeyX1

M0.31x3.54"

rew

For wood stud and

concrete wall

Ø0.39"

Anchor

Just for concrete

wall





Floor GuideX1

rewX2

AnchorX2



Scan Here For Latest

Version (01-Installation Guide)

Door HandleX1

In case of questions or missing parts,please contact

Dooraftersale@gmail.com

Summary of content (6 pages)

PAGE 1
Barn Door Hardware INSTALLATION MANUAL In case of questions or missing parts,please contact Dooraftersale@gmail.com 2 PERSON ASSEMBLY UP TO 30 MIN. ASSEMBLY Scan Here For Latest Version (01-Installation Guide) Hardware Included 1 3 5 2 Rail Ø0.39" Anchor Just for concrete wall T shape Floor GuideX1 Wall Spacer ScrewX2 HangerX2 4 M0.31x3.54" Screw For wood stud and concrete wall 6 An�-jump blockX2 M0.39x2.
PAGE 2
Tools required Speed Square Pencil Phillips Screwdriver Tape Ø7/32” Ø3/8” Wrench Level Drill Drill Bit Measure Before You Start Ceiling A G 16” B 16” 1.61” 16” C E 39/16” 16” F ” D A Overall rail length is 5.5�/6�/6.6�/7�. B The gap between each pre-drilled hole is 16". C Distance from door top side to holes on the wall is 1 5/16". D Distance from the bo�om of the door to the ﬂoor is 3/8". E Door height is H.
PAGE 3
Important Notes It is very important to determine whether you need to install a Header Board before you install the track. IF you meet the following situa�ons, we highly recommend you using a Header Board.
PAGE 4
Track Installation Step-1 Drill the marked holes with drill bits. A Concrete Wall Drill the holes with .
PAGE 5
Door Preparation Step-3 Our doors are pre-drilled Install hangers on the top side of the door using door lag bolts according to the pictures below. Make sure the door lag bolts are located in the middle line of the door top side. Step-4 Use router or circular saw to create a kerf at bo�om of the door, along the center to allow the �p of the T-shaped ﬂoor guide to ﬁt in between.
PAGE 6
Hang Your Door Step-5 Install the ﬂoor guide. a. Put the ﬂoor guide on the ﬂoor ﬁrst to a suitable posi�on, sliding the door so that the �p of the ﬂoor guide can work well in the slot of the bo�om of the door. And then mark 2 holes of the ﬂoor guide. b. Use drill bit to drill holes on the ﬂoor where the mark is, and then install the ﬂoor guide. / ” 7 32 Ø 3/8 ” Step-6 The an�-jump blocks are used to protect the door from touching the rail when sliding the door.