Owners manual

ManualsBrandsAries ManualsAutomotiveARIES 2074109 Rocker Steps

PAGE 1 • 2074109-INS-RB • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM

Product Image

Notes and Maintenance

Before you begin installation, read all instructions thoroughly.

Proper tools will improve the quality of installation and reduce the time required.

For black ﬁnishes, mild soap may be used to clean the product.

Refer to the table to the left when securing hardware during the

installation process to help prevent damage to the product or vehicle.

Level of Difﬁculty

Easy

Parts List

1 Driver / left rocker step

1 Passenger / right rocker step

1 Passenger / right

mounting bracket, front

1 Passenger / right

mounting bracket, top front

12 Clip nut, M8

1 Bolt plate, M8 - 1.25 x 30mm

15 Hex bolt, M8 - 1.25 x 25mm

17 Flat washer, M8

13 Lock washer, M8

3 Nylock nut, M8

Scan

for helpful

install tips

Front

Rear

INSTALLATION MANUAL 2074109

Torque Speciﬁcations

METRIC

M6 bolt 3 ft.-lbs.

M8 bolt 7 ft.-lbs.

M10 bolt 16 ft.-lbs.

M12 bolt 28 ft.-lbs.

SAE

1/4" bolt 3 ft.-lbs.

5/16" bolt 7 ft.-lbs.

3/8" bolt 16 ft.-lbs.

7/16" bolt 20 ft.-lbs.

1/2" bolt 28 ft.-lbs.

Tools Required

Torque wrench Socket, 13mm

Flathead

screwdriver

Wrench, 13mm

Summary of content (3 pages)

PAGE 1
INSTALLATION MANUAL Parts List Level of Difficulty 1 Driver / left rocker step Easy 1 Passenger / right rocker step 1 Passenger / right mounting bracket, front 1 Passenger / right mounting bracket, top front 12 Clip nut, M8 1 Bolt plate, M8 - 1.25 x 30mm 15 Hex bolt, M8 - 1.
PAGE 2
Step 1 Starting on the driver side, locate the three mounting points along the bottom edge of the vehicle. Step 2 Locate the front mounting tab, slide a clip nut over the lower mounting point. Note: Depending on the model year the use of an additional clip nut may be needed for the upper mounting point. Using a flathead screwdriver, remove the hole plug and insert a clip nut in through the access hole and slide the clip nut over the adjacent small hole.
PAGE 3
Step 5 Slide the mounting bracket down the rocker panel and position the bracket over the mounting hole along the edge of the rocker panel. Slide an M8 bolt plate in through the top of the rocker panel and down through the mounting bracket and mounting point. Secure the mounting bracket using an M8 flat washer and nylock nut. Step 6 Attach the passenger front mounting bracket to the rocker step using two M8 hex bolts, four M8 flat washers and two M8 nylock nuts.