CPE2630 Quick Installation Guide
1. Check the parts in your box CPE SET 1 DC 12V @ 1.25A Power Adapter 1 PoE DC Power Injector 1 Hose Clamps 2 CD user manual 1 2. How to fix the CPE on the Pole (1”- 1.
. PoE connection 1. Connect (POE) RJ45 Jack to CPE RJ45 Jack with good quality Ethernet cable. 2. Connect (LAN) Jack to PC or Switch Hub LAN port. 3. Plug in the power adaptor to PoE DC jack. 4. CPE Connection 1. Open the CPE enclosure you will find one RJ45 Jacks two LEDs and one reset button. 2. Connect the PoE cable to either LAN port. 3. To reset the CPE just press and hold the reset button for about 10 seconds and wait for 35 seconds to reboot the CPE.
The device has four operation modes (Gateway/Bridge/WISP/AP Client). Bridge/WISP/AP Client: The default IP addresses for the device are 10.10.10.254, so you need to make sure the IP address of your PC is in the same subnet as the device, such as 10.10.10.X. It will take about 25 seconds to complete the boot up sequence after power on from PoE. Gateway: The default IP addresses for the device are 172.32.1.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 50cm between the radiator & your body. Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
Professional installation instruction Please be advised that due to the unique function supplied by this product, the device is intended for use with our interactive entertainment software and licensed third-party only. The product will be distributed through controlled distribution channel and installed by trained professional and will not be sold directly to the general public through retail store. 1.